Chief CMA643 Installation Guide

INSTALLATION INSTRUCTIONS

Chrome Ceiling Ring Accessory

CMA643

CMA643 Installation Instructions

(A)

DISCLAIMER

CSAV, Inc., and its affiliated corporations and subsidiaries
(collectively, "CSAV"), intend to make this manual accurate and
complete. However, CSAV makes no claim that the information
contained herein covers all details, conditions or variations, nor
does it provide for every possible contingency in connection
with the installation or use of this product. The information
contained in this document is subject to change without notice
or obligation of any kind. CSAV makes no representation of
warranty, expressed or implied, regarding the information
contained herein. CSAV assumes no responsibility for
accuracy, completeness or sufficiency of the information
contained in this document.

IMPORTANT WARNINGS AND

CAUTIONS!

WARNING:

serious injury or death if you do not follow the instructions.

CAUTION:

damage or destruction of equipment if you do not follow the
corresponding instructions.

A WARNING alerts you to the possibility of

A CAUTION alerts you to the possibility of

INSTALLATION

1. Install ceiling plate, extension accessories and projector
following installation instructions provided by manufacturer.

2. Spread open the CMA643 (A). (See Figure 1)

Figure 1

3. Place CMA ring around the pipe with tabs facing up, and
close CMA.

4. Press tabs in toward pipe to hold CMA in place at the
ceiling. (See Figure 2)

WARNING:

follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.

WARNING:

for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.

Failure to read, thoroughly understand, and

Failure to provide adequate structural strength

PARTS

Figure 2

2