Chicony Electronics Co RC 0617 User Manual

A. FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to
Part 15 the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.

WARNING:
Use only shielded cables to connect I/O devices to this equipment. You are cautioned that changes or
modifications not expressly approved by the party responsible for compliance could void your authority to
operate the equipment.

CAUTION: AVOID PROLONGED USE OF THE REMOTE WITHOUT BREAKS.
Take regular breaks and keep a good posture. Consult your physician promptly if you notice any lost of motion
or pain in your wrist when using the remote.

I
B. PRODUCT SPECIFICATION

1 Frequency band : 2402MHz-2479 MHz
2 Frequenc y modulation : GFSK mode
3 Transmitter power : 0dBm
4 Power Requirement: 2V~3.2V
5 Battery: Remote Control : 2 pieces of AAA Batteries

6 Operation distance :Remote Control: 10 M without signal disturbance and no direction limit.
7 Operating temperature : -10
8 Storage temperature : -40

o

C~ +40o C.

o

C ~ +90o C.

Contents

Getting

Started..............................................................................

.................................... 1

Features.............................................................................

............................................... 1

Preparing Remote and

Receiver..................................................................... 1

Hardware

Installation.........................................................................

............................... 1

Connect the

receiver.............................................................................

............................ 1

Inserting

batteries............................................................................

................................. 1

Setting frequency channel or

ID...................................................................................

..... 2

Setting frequency channel on
remote

………………….…................................................ 2

Setting ID on

….............................................................................

remote

........................ 2

Working with

Remote...............................................................................

..........................2

How to use remote…..……………………………………………………………………………2

How to use the remote

properly ……........................................................................

......... 3

Cleaning the

remote .. ...........................................................................

.............................4

Troubleshooting and

Tips...................................................................................

............... …5

English

Getting Started

Thank you for choosing this Wireless Remote set. It operates with digital
radio technology to ensure no hinder communication between the remote
and your computer without connecting cable. The transmission and
receiving of remote are free from angle restriction. There are 78 frequency
channels for remote to prevent malfunctions when you operate several
radio transmission devices simultaneously.

Features
USB Interface

1 Plug the receiver connector into an USB port.
2 SYSTEM will take around 10 sec to find your remote automatically.

(PS : If your OS is Windows® 98, please follow the screen instruction to complete your
remote installation)

3 Please keep your receiver from the other electrical devices about 8 inches. The