Chicony Electronics Co MT 0975 User Manual
Bluetooth 3.0 Mouse Kits User’s Manual
FCC:
*
Radiation Exposure Statement:
TThe product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe
for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower output power if such function is available.
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference; and
• This device must accept any interference received including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Use only shielded cables to connect I/O devices to this equipment. You are cautioned that changes
or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
CE Statement of Compliance with EU Directive
*
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC.
This device is a 2.4 GHz wideband transmission system (transceiver) intended for use in all EU member states and
EFTA countries.
Operating / Storage temperature: 0°C ~ +40°C / -40°C ~ +65°C.
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled environment and are safe
for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower output power if such function is available.
Déclaration d’exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les Etats-Unis et le
Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux expositions RF peut être
augmentée si l'appareil peut être conservé aussi loin que possible du corps de l'utilisateur ou que le dispositif est réglé
sur la puissance de sortie la plus faible si une telle fonction est disponible.
Industry Canada Statement
This device complies with RSS-210 of Industry Canada rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux appareils radio exempts de licence.
Son fonctionnement est aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable,
et (2) ce dispositif doit accepter tout brouillage recu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
IMPORTANT BATTERY INFORMATION
● Keep batteries out of reach of children.
● Insert the batteries in the proper direction as indicated by the positive (+) and negative (-) markings in the battery
compartment.
● Do not mix old and new batteries or batteries of different types (for example, carbon and alkaline batteries).
● Always remove old, weak, or worn-out batteries promptly and recycle or proper disposal of them in accordance with
Local and National Disposal Regulations.
● If a battery leaks, remove all batteries and recycle or dispose of them in accordance with the battery manufacture's
instructions and Local and National Disposal Regulations. Before inserting new batteries, thoro
compartment with a damp paper towel, or follow the battery manufacture's recommendations for cleanup. If fluid from
the battery comes into contact with skin or clothes, flush skin with water immediately.
● Remove the batteries if your device is to be stored for an extended period of time without being used.
PRODUCT DISPOSAL INFORMATION
Dispose of this product in accordance with Local and National Disposal Regulations.
ughly clean the
~ English ~
Bluetooth 3.0 Mouse Kits User’s Manual
PRODUCT SPECIFICATION
1. Power requirement: 3V
2. Battery :
3. Battery life time :
4. Operation distance :
5. Mouse resolution : 1000 DPI
6. System OS support: Windows 2000/XP/Vista/Windows 7 / Windows 8
7. Operating temperature : 0°C ~ +40°C
8. Storage temperature : -40°C ~ +65°C
2 pieces of AAA Batteries
200 hours reference (operating mode)
10M without signal disturbance and no direction limit.
Getting Started
Bluetooth 3.0
Preparing mouse and receiver
Before working with your new mouse, look at the "Hardware Installation", and take a few one-time
preparations.
Hardware Installation
●
Do not place the receiver on metal surfaces.
● Do not move optical mouse on following surface - Glass or any transparent materials
Dark surface
Mirror or reflecting surface
Mouse pad with too many colors
Rough surface.
Step 1: Insert batteries
Inserting batteries in mouse
The mouse requires two alkaline AAA batteries.
● Remove the battery compartment cover on the bottom of the mouse
● First push the battery puller in then insert two AAA batteries
into battery compartment.
● Fix the battery compartment cover
on the bottom of mouse again.
Step 2: Switch power key to turn on mouse
Step 3: To push connect button in pairing mode
Turn on Bluetooth for one second and release, the Bluetooth LED starts blinking,
and select Bluetooth Mouse on tablet PC.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to instructions.
Refer to "Important Battery Information" for disposal instructions.
Cleaning the mouse
● Use disinfectant wipes to clean the mouse.
● Do not use any dissolvent, which may damage the surface of your mouse.
Troubleshooting and tips
The mouse does not operate following installation or is not recognized.
● Make sure that the batteries have been inserted correctly according to the polarity and the receiver is well connected.
● Make sure the batteries are not too weak.
● Remove the batteries from the device. Please press any button on the device several times to prevent any unexpected
failure after batteries being put in.
● To determine whether the mouse or computer causes
or test another mouse on your current computer.
If you are still unable to solve the problem, please contact your point of sale or your dealer.
If you need to exchange the mouse, please note that you must return it to your dealer in its original packaging and also
a produce proof of purchase (receipt). Keep your receipt in a safe place after purchase.
the problem,test the mouse on another computer if possible;
~ English ~
Loading...