Chicony Electronics Co KG 0917 User Manual

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT

This equipment has been tested and found to comply with the limits for a Class
B digital device, Pursuant to Part 15 the FCC rules / RSS-210. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference will not occur in
a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules / RSS-210. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.

WARNING:

You are cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void your authority to operate the
equipment.

低功率電波輻射性電機管理辦法:
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得
擅自變更頻率、加大功率或變更設計之特性及功能。

第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現
象時，應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干
擾。

INFORMATION FOR OPTICAL POINTING DEVICES ONLY:

This product has been tested to comply with international Standard IEC
60825-1:(1993), incid. Amd.2(2001). This product uses LEDs that are
inherently Class 1.

Class 1 LED Product

Product Specification

Frequency: 2402MHz ~ 2479 MHz (78 channel)
Modulation Type: DSSS
Frequency Deviation: 125 KHz
Power rated: 3V (Keyboard) / 3V (Mouse) / 5V (Dongle)
Battery: Keyboard – 2 pieces of AAA Batteries
Mouse – 2 pieces of AAA Batteries
Operation distance: Keyboard – 10M without signal disturbance and no

direction limit

Mouse – 10M without signal disturbance and no

direction limit

Mouse resolution: 800 DPI
Operating temperature: 0°C ~ +40°C
Storage temperature: -40°C ~ +65°C