Chevrolet 6405, 4410TK, Power Vision, 4410 User Manual
POWER VISION
INSTALLATION INSTRUCTIONS
Models: 6405/4410 & 6405/4410TK GM/Chevrolet 2007 – current (new body style) full size trucks and
SUVs with manual power mirrors.
THIS SET IS DESIGNED FOR TRUCK WITH STOCK MANUAL MIRRORS. IF YOU
CURRENTLY HAVE POWER MIRRORS, THE WRONG SET HAS BEEN ORDERED .
Caution! - Do not attempt to manually extend or retract the mirrors. They should be moved under their own
motor power only.
Tools required for the installation are: 7mm and 10mm sockets, trim panel remover, philips screwdriver, small
screwdriver, needle nose pliers, razor knife, and an inch pound torque wrench. If you have any questions after
reading this installation manual, please call our service department at (800) 337-2557.
REMOVAL OF EXISTING MIRRORS
1. On the inside of the driver’s door, remove the triangular shaped trim piece and insulation foam in the
mirror mounting area.
2. Remove the door lock by using a small screwdriver to release the tab
while lifting the lock upward.
3. Remove door trim panel screws located under trim covers.
4. Remove window handle by releasing the retaining clip.
6405/4410 Install
PAGE 2
5. The door trim panels have a series of snaps around the outer edges. Unsnap the door trim panel.
6. Remove the door trim panel:
Release the door handle cable by
compressing the cable lock with needle
nose pliers (as shown), rotate until ball
lines up with the slot, then lift upward.
Remove the trim panel.
7. Support the stock mirror while removing the 3 mirror mount lug nuts using a 10mm socket. Save the
stock nuts for later in the install.
8. Release the clip at the top of the mirror door bracket (as in
photo). Remove the stock mirror. Save the stock gasket and
nuts, as they will be reused.
9. Repeat this process for the passenger side.
ASSEMBLY AND MOUNTING POWER VISION MIRRORS:
1. Attach the mirror door mount bracket (“mount”) to the
mirror using 3 of the #8 screws with yellow patch provided
in the hardware bag. (Note: This is also where you can
adjust the sweep of the mirror in relation to the door later on
if necessary.)
2. Plug the cord coming through the mount into the cord under the boot.
3. Place the open end of the boot around
the lip on the mount to hold it in place.
Loading...