4
REMOTE KEYLESS ENTRY TRANSMITTER
Unlock
Press to unlock the driver’s door only or all doors. The
unlock setting can be changed in the Vehicle Settings menu
by pressing the CONFIG button on the audio system.
Lock
Press to lock all doors. The driver’s door will not lock
if open.
Trunk
Press and hold to unlatch the trunk.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle. The turn signal
lamps will flash and the horn will sound.
Press and hold to activate the alarm. The turn signal lamps
will flash and the horn will sound until the button is pressed
again or the ignition is turned on.
Remote Vehicle Start✦
Use to start the engine from outside the vehicle.
REMOTE VEHICLE START✦
During a remote start, the vehicle’s climate control system will operate at the same setting
as when the vehicle was last turned off and, based on outside temperature, the heated
seats will turn on. The heated seats will turn off when the ignition is turned on.
Starting the Vehicle
1. Aim the Remote Keyless Entry transmitter at the vehicle. (Transmitter range depends
on operating conditions.)
2. Press and release the Lock button on the transmitter.
3. Immediately press and hold the Remote Start button for at least two seconds.
When the vehicle starts, the parking lamps will light and remain on while the engine is
running. The engine will continue running for 10 minutes.
4. Repeat these steps for a 10-minute time extension. Remote start can be extended
only once.
After a remote start, the ignition must be turned to the On position before driving.
Canceling a Remote Start
• Press and hold the Remote Start button until the parking lamps turn off.
Note: Several conditions will cause the Remote Vehicle Start feature not to operate, such as if the
key is in the ignition or the hood or doors are not closed.
See Keys, Doors and Windows in your Owner Manual.