Page 1
Power Amplifier Q6
The classic Chevin A-Series amplifier is built in a steel and aluminium housing
incorporating lateral Mosfets and the Chevin Power Supply. This combination
produces the traditional Chevin sound.
Technical specification
RMS power output
into 8Ω (per channel)
into 4Ω (per channel)
Number of channels
Power bandwidth +0db, -3db 2 Hz – 80 kHz
Slew rate in excess of
Gain
Total harmonic distortion
typical @ 1db below clip 0,04 %
20 kHz @ 1db below clip 0,07 %
Signal to noise ratio
typical reference full output, unweighted -125 dB
Worst case 10 Hz – 30 kHz -95 dB
Crosstalk typical -115 dB
Damping factor
Input impedance electronically balanced
Common mode recetion (typical)
Input sensitivity
Reference full output into 4 Ω
Protection
Clipping, load below 2.4 soft, dynamic linear shorted output, DC or RF at output immediate
Power consumption
1/3 Power typical Program 1,3 kVA 50/60 Hz AC in Volts 220 – 240 V Internally selectable for 100 – 120 V
Dimensions/weight
height x width x depth (mm) / rack units 88 x 483 x 381 / 2U Net weight 12,3 kg
350 W
600 W
4
75 V / μS
x 50
400
10 kΩ
-70 dB
1V RMS
©2008 Chevin Research Product design and specifications may change without prior notice
Loading...