Unless otherwise indicated, all materials in this manual are copyrighted by Chenbro Micom Co., Ltd.. All rights
reserved. No part of this manual, either text or image may be used for any purpose other than internal use within
purchasing company. Therefore, reproduction, modification in any form or by any means, electronic, mechanical or
otherwise, for reasons other than internal use, is strictly prohibited without prior written permission.
Chenbro Micom Co., Ltd. reserves the right to make improvement and modification to the products indicated in this
manual at any time. Specifications are therefore subject to chan ge without prior notice.
Information provided in this manual is intended to be accurate and reliable. However, Chenbro Micom Co., Ltd.,
assumes no responsibility for its use, nor for any infringements upon the rights of third parties, which may result from
its use.
Technical Support
Chenbro works hard to offer our customers maximum performance from our chassis. But in case you have
any problem with our product you can find supports from the following resources.
Web Support
Detail information of our products is in our website. You can find technical updates, installation guides, FAQs,
technical specifications and more. Our web address is: www.chenbro.com
Email Support
You can also fill out the technical support form at our Technical Support page. You technical issue inquiries will be
sent directly to our support professionals.
Phone Support
Y ou can also cont act Chenbro HQ or branch offic e for immediate support; cont act Infor mation is as follo wing:
(1) [CN11 / CN21 / CN31 / CN41] : Connect to 22-pin SATA-II or 29-pin SAS HDD
(2) [JF1 / JF2 / JF3 / JF4 / JF5] : Fan connectors 1~5
(3) [CN2] : HDD Failure LED Signal Pin Header
JF1
JF2 JF3 JF4 JF5
CN1
HDD
Rear View
HDD 1
HDD 2 HDD 3
CN9
CN41 CN31 CN21 CN11
CN10
CN2 CN4 CN3
CN8
Connect the 4-pin HDD LED cable (26H113322-001) from CN2 to the CATHODE
of the HDD failure connector on RAID card. Refer to the RAID card’s user
manual for the detail pin definition.
(4) [CN3] : Reserved for factory use only
(5) [CN4] : Backplane ID setting jumper
Jumper
Setting
Backplane
ID
(6) [CN5] : Signal connector (Board to Board Connection )
(7) [CN6 / CN7] : 4-pin Power connectors
(8) [CN8] : Reserved for factory use only
(9) [CN9] : SGPIO HDD fail function jumper
Jumper Closed: Enable SGPIO HDD Failure Signal (Default)
Jumper Opened: Disable SGPIO HDD Failure Signal
Close
Pin 1 & 2
1 2 3 4 5 6
Close
Pin 3 & 4
Close
Pin 5 & 6
Close
Pin 7 & 8
Close
Pin 9 & 10
Close
Pin 11 & 12
www.chenbro.com
(10) [CN10] : SGPIO HDD access function jumper
Jumper Closed: Enable SGPIO HDD Access Signal
Jumper Opened: Disable SGPIO HDD Access Signal (Default)
15Fl., No.150, Jian Yi Road, Chung Ho City, Taipei Hsien, Taiwan R.O.C.,