Unless otherwise indicated, all materials in this manual are copyrighted by Chenbro Micom Co., Ltd.. All rights
reserved. No part of this manual, either text or image may be used for any purpose other than internal use within
purchasing company. Therefore, reproduction, modification in any form or by any means, electronic, mechanical or
otherwise, for reasons other than internal use, is strictly prohibited without prior written permission.
Chenbro Micom Co., Ltd. reserves the right to make improvement and modification to the products indicated in this
manual at any time. Specifications are therefore subject to change without prior notice.
Information provided in this manual is intended to be accurate and reliable. However, Chenbro Micom Co., Ltd.,
assumes no responsibility for its use, nor for any infringements upon the rights of third parties, which may result from
its use.
Technical Support
Chenbro works hard to offer our customers maximum performance from our chassis. But in case you have
any problem with our product you can find supports from the following resources.
Web Support
Detail information of our products is in our website. You can find technical updates, installation guides, FAQs,
technical specifications and more. Our web address is: www.chenbro.com.
Email Support
You can also fill out the technical support form at our Technical Support page. You technical issue inquiries will be
sent directly to our support professionals.
Phone Support
You can also contact Chenbro HQ or branch office for immediate support; contact Information is as following:
Components Description Function
CN011 ~ CN121 29 pin SAS Connector – to HDD For SAS/SATA HDD connection
CB1 ~ CB3 Mini-SAS SFF-8087
Connector – Input
JF1 ~ JF4 PWM fan Connector Chassis cooling fan connection
CN01 ~ CN04 Power Connector DC in, 4-Pin, +5V/+12V from Power Supplier
SW1 DIP Switch The function is for fan control enable and disable
JP1 Power Failure Alarm Connector Connect to Redundant PSU for power failure alarm
JM1 Power Failure Mute Connector Connect to Redundant PSU for power failure mute
CN05 LED board connector Signal connection to chassis LED board
CN06 M/B PWM fan Connector Gets either PWM duty cycle of M/B or B/P for
Internal input from SAS RAID Card or M/B
switching.
signaling
signaling
comparison to control fan speed , required one
optional special cable (26H11313601A0)
(Please see Appendix 1 for duty cycle definition)
JA3/JA4 Multi ICE pin connector Factory reserved for upgrade & debug
JP2/JP3 IIC Connector Factory reserved
JT1/JT2 Test Connector Factory reserved for thermal contact
w w w . c h e n b r o . c o m
15Fl., No.150, Jian Yi Road, Chung Ho City, Taipei Hsien, Taiwan R.O.C.,
The Chenbro 12-Port 6Gb/s Mini-SAS Backplane can be assembled on Chenbro Storage Server Chassis
RM23612 only. Please refer to the Chassis Quick Installation Guide for detail information.
Figure : Front and Rear View of 12 port Backplane
Backplane Wiring
Chassis Fan x4 ( Max.)
HBA / RAID Card
Mini-SAS cable
Fan cable
M/B PWM / clock Fan signal
Note :
cable ( 2-pin to 4-
www.chenbro.com
This optional cable
(26H11313601A0) subjects to PWM
and clock signal connection
between M/B and B/P, to get PWM
duty signal ( depends on thermal
sensor on M/B ) for comparison
with B/P and control fan speed.
Meantime, report fan clock signal to
M/B for fan speed indication in the
system.
15Fl., No.150, Jian Yi Road, Chung Ho City, Taipei Hsien, Taiwan R.O.C.,