Page 1
141°F Initial
Solubility in Water
20%
Specific Gravity
0.70
Evaporation Rate (butyl acetate=1) >1
Appearance Clear, Colorless Liquid
Odor
Mild
Vapor Pressure 198 mm Hg @ 68 F (liquid)
Surface Tension 17.3 dynes/cm @21.6°C
Flash Point (TCC)
-20.0°F
VOC* Content: Aerosol Liquid
Federal 74% 100 %
RoHS Compliant
Shelf life Aerosols 5 years
Liquids 2 years after opening
CHEMTRONICS
Technical Data Sheet
TDS # FSP850
FsP Fiber Optic Cleaner
PRODUCT DESCRIPTION
Fsp Fiber Optic Cleaner employs the same
proven solvent blend as Electro-Wash
which is a fast drying, one step precision
cleaning and degreasing agent safe for most
plastics. FsP (Fusion Splice Prep) is
especially configured for one-touch ease of
dispensing when servicing fusion splice
equipment or wiping ca bles and fiber prior to
splicing. Engineered with very low surface
tension, this high pressure aerosol
formulation evaporates quickly leaving no
residue.
Removes encrusted dirt, grease and other
contaminants
Especially effective at removing buffer
gel and complex soils in the splicing
environment
Also effective on fiber e nd faces
Penetrates hard to reach areas
Evaporates quickly
Leaves no residues
Has low odor
Is non-corrosive
Contains no CFCs or HCFCs
Contains no 1,1,1 Trichloroetha ne
TYPICAL APPLICATIONS
FsP cleans and degreases:
Cable prep for fusion splice
Use with FsW wipers for cable wiping
and fusion splice machine clean-up
Use to dampen swabs for V-groove
cleaning and mirror cleaning
PX,
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
Boiling Point
Vapor Density (air=1)
Kauri-Butanol (KB) Number 50
CARB 74% 100 %
SCAQMD 700 g/L 690 g/L
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
>1
COMPATIBILITY
Electro-Wash
PX is generally compatible
with most materials used in the electronics
industry. With any cleaning agent
compatibility must be determined on a noncritical area prior to use
Page 2
Material
Compatibility
ABS
Good
Buna-N
Good
EPDM
Poor
Graphite
Excellent
HDPE
Excellent
Kynar
Fair
LDPE
Fair
Lexan
Fair
Neoprene
Fair
Noryl
Good
Nylon 66
Excellent
Cross-Linked PE
Excellent
Polypropylene
Good
Polystyrene
Non-Compatible
PVC
Good
Silicone Rubber
Non-Compatible
Teflon
Excellent
Viton
Excellent
(mg solvent / 1 mg oil)
33
Conventional CFC
11
Conventional CFC
HCFC-141b
HCFC-225
None
None
HFC
nPB
None
None
Performance
Product Required for Water Soluble Oil Removal
Electro-Wash PX / FsP
Cleaner
Water Soluble Oil Removal Rate (mg / in∧2 sec.)
94
AVAILABILITY
FSP850 5 oz. Aerosol
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to answer
your technical and application related questions.
The toll free number is: 1-800-TECH-401.
ENVIRONMENTAL IMPACT DATA
Hydrochlorofluorocarbons (HCFCs) are regulated un der the Mont real Protocol
as Class II ozone depleting substances. HCFC-141b is no longer produced in
the US under this legislation. HCFC-225 is planned for production phase-out
in 2015. Hydrofluorocarbons (HFCs) are not currently regulated.
EPA has listed n-propyl bromide (nPB) as an acceptable alternative to ozone
depleting substances in metal, precision, and electronics cleaning under
Section 612 of the Clean Air Act.
NOTE:
This information is believed to b e accurate. It is intended for
professiona l end user s having the skill s to evaluate and use the
data properly. CHEMTRONICS does not guarantee the
accuracy of the data and assumes no liability in connection with
damages incurred while using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888 REV. B (08/13)
Electro-Wash PX / FsP
Cleaner
5
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Remove cap and place can on firm stable work
surface. With wiper in hand, press down on the
vertical aerosol dispenser. Spray will shoot up
into the wipe. Wipe cable or fiber with the wet
wiper to achieve ‘squeaky’ clean. Product is
Extremely Flammable - Do not use near sources
of ignition and energized equipment.
DISTRIBUTED BY:
Loading...