Page 1
Boiling Point
95°F
Flash Point (TCC)
None
Solubility in Water
Negligible
Specific Gravity
1.24
Evaporation Rate
(Butyl acetate=1)
>1
Surface Tension
(dynes/cm @ 25°C)
14.1
Kauri-Butanol (KB) Number 26
Dielectric Breakdown
(ASTM D-877)
17 kV
VOC* Content (aerosol):
Federal 19 %
RoHS Compliant
CHEMTRONICS
Technical Data Sheet
Electro-Wash VZ
Cleaner Degreaser
TDS # 6100
PRODUCT DESCRIPTION
Electro-Wash VZ Cleaner Degreaser is an
all purpose cleaner for electronics that is
nonflammable, non-ozone depleting, and
low odor. This fast drying precision cleaner
contains the Verizane
Ozone Safe
Replacement Chemistry, formulated with
DuPont
Vertrel Specialty Fluids. It is
excellent for removing grease, oil, and flux
residues from ene rgized equipment.
Removes dirt, oil, grease, flux and many
other contaminants
Nonflammable
Non-ozone depleting
Leaves no residues
Evaporates quickly
Low Odor
Contains no CFCs, HCFCs, or
1,1,1 Trichloroethane
TYPICAL APPLICATIONS
Electro-Wash
VZ Cleaner Degreaser is
excellent for cleaning:
Printed Circuit Boards
Contacts
Cable Assemblie s
Magnetic Heads
Electronic Controls
Edge Connectors
Light Flux Residues
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
CARB 45 %
SCAQMD 412 g/L
Shelflife 5 years aerosol / 2 years liquid
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
COMPATIBILITY
Electro-Wash
VZ Cleaner Degreaser is
generally compatible with most materials
used in the electronics industry. With any
cleaning agent compatibility must be
determined on a non-critical area prior to
use.
Page 2
Material
Compatibility
ABS
Poor
Buna-N
Good
EPDM
Good
Graphite
Good
HDPE
Good
Kynar
Good
LDPE
Good
Lexan
Poor
Neoprene
Good
Noryl
Good
Nylon 66
Good
Cross-Linked PE
Good
Polypropylene
Good
Polystyrene
Poor
PVC
Good
Silicone Rubber
Good
Teflon
Good
Viton
Good
HCFC-141b
HCFC-225
None
None
HFC
nPB
Yes
None
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS care fully prior to use.
Spray 4-6 inches from surface to clean.
Wash parts from top to bottom, allowing the
liquid to flush away flux residues, dirt and
dissolved oil. For precision application use
attached extension tube.
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your tec hnical and application related
questions. The toll free number is: 1-800-
TECH-401.
AVAILABILITY
ES6100 12 oz. Aerosol
ES6119 19 oz. Aerosol
ES6101 1 Gallon
ES6155 53 Gallon
ENVIRONMENTAL IMPACT DATA
Hydrochlorofluorocarbons (HCFCs) are regulated un der the Montreal Prot ocol
as Class II ozone depleting substances. HCFC-141b is no longer produced in
the US under this legislation. HCFC-225 is planned for production phase-out
in 2015. Hydrofluorocarbons (HFCs) are not currently regulated.
EPA has listed n-propyl bromide (nPB) as an acceptable alternative to ozone
depleting substances in metal, precision, and electronics cleaning under
Section 612 of the Clean Air Act.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly.
CHEMTRONICS does no t guarantee t he accuracy of
the data and assumes no liability in connection with
damages incurred while using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
Electro-Wash and Chemtronics are registered
trademarks of Chemtronics. All rights reserved.
Verizane, is a trademark of Chemtronics. All rights
reserved.
Vertrel® and DuPont
trademarks of E. I. duPont de Nemours and Company.
DISTRIBUTED BY:
are trademarks or registered
REV. E (08/13)
Loading...