Vapor Pressure @68°F <1.0 mmHg
Appearance Clear, colorless liquid
VOC* Content: Aerosol Liquid
Liquids 2 years after opening
CHEMTRONICS
Technical Data Sheet
Max-Kleen™ Citrus HF
The high flashpoint citrus degreaser
PRODUCT DESCRIPTION
Max-Kleen™ Citrus HF Degreaser is ideal for
removal of all types of soils including oxidized
grease, sludge, wax, tar and oil. The moderate
evaporation rate increases the cleaning power
for hard-to-remove soils. The low surface
tension provides for superior wetting to clean in
even the tightest spots. Max-Kleen™ Citrus HF
Degreaser has a flash point greater than 140º F
which may be advantageous when planning for
disposal of used rags.
• Citrus-based formula with moderate
evaporation rate
• Quickly removes all types of tough soils
including oxidized oil and grease
• Safe for use on most metals and plastics
• VOC compliant degreaser
• Flashpoint greater than 140º F
• Non-corrosive and nonconductive
• Low Toxicity
• Leaves no residue
TYPICAL APPLICATIONS
Max-Kleen™ Citrus HF Degreaser can be used
for all repair, maintenance, and manufacturing
applications including:
• Removes grease, oil and lubricants
• Ideal for metal parts cleaning and tools
• All repair and maintenance cleaning
• Cleans contacts, relays, switches, circuit
breakers and test probes
• Cleans electric motors and gasoline engines
• Removes tough soils from gears and pulleys
• Use for maintenance of air compressors
• Cleans inks and residues from printing
presses
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
(butyl acetate=1)
Kauri-Butanol (KB) Number 45
CARB 50% 4 %
SCAQMD 390 g/L 31 g/L
Shelflife Aerosols 5 years
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
COMPATIBILITY
Max-Kleen™ Citrus HF Degreaser is
compatible with most metals and plastics. As
with any solvent, compatibility with substrate
should be determined on a non-critical area
prior to use.
USAGE INSTRUCTIONS
Read MSDS carefully prior to use.
Sp ra y 4-6 inches from surface t o clean. Wash p arts
from top to bottom, allowing the liquid to flush
away dirt and dissolved grease. For precise
application use attached extension tube.
For wipe applications, wet a Controlwipes™ Wipe
with Max-Kleen™ Citrus HF Degreaser and
wipe away soils.
ENVIRONMENTAL IMPACT DATA
Hydrochlorofluorocarbons (HCFCs) are regulated under the Montreal
Protocol as Class II ozone depleting substances. HCFC-141b is no longer
produced in the US under this legislation. HCFC-225 is planned for
production phase-out in 2015. Hydrofluorocarbons (HFCs) are not currently
regulated.
EPA has listed n-propyl bromide (nPB) as an acceptable alternative to ozone
depleting substances in metal, precision, and electronics cleaning under
Section 612 of the Clean Air Act.
AVAILABILITY
ES2291 13.5 oz aerosol
ES191 1 gallon liquid
ES591 5 gallon liquid
ES5591 53 gallon liquid
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to answer
your technical and application related questions.
The toll free number is:
1-800-TECH-401.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly.
CHEMTRONICS does not guarantee the accuracy
of the data and assumes no liability in connection
with damages incurred while using it.
Chemtronics is a registered trademark of Chemtronics. All rights
reserved. Controlwipes are trademarks of Chemtronics. All rights
reserved.
All other trademarks herein are trademarks or registered
trademarks of their respective o wner s .
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
DRAFT A (08/13)
DISTRIBUTED BY: