Boiling Point
99F (Initial)
Evaporation Rate (butyl acetate=1) >1
Flash Point (TCC)
None
Appearance Clear, Colorless
Liquid
Odor
Ethereal
Specific Gravity
1.30
Vapor Pressure @68F 51 mmHg
Solubility in Water
Negligible
Dielectric Breakdown
(ASTM D-877)
30 kV
Surface Tension 15
(dynes/cm @ 73F)
Kauri Butanol Number
60
VOC* Content: Aerosol
CARB 73%
SCAQMD 695 g/L
Federal 56%
RoHS Compliant
Shelflife 5 years
CHEMTRONICS
Technical Data Sheet
Pow-R-Wash Delta
Electronics Contact Cleaner
TDS # DEL1681
PRODUCT DESCRIPTION
Pow-R-Wash Delta electronics contact cleaner
is a highly efficient and effective solvent cleaner
for electrical and electronic components and
assemblies. This cleaning agent is both
nonflammable, and engineered to be compatible
with most metals and plastics found in electronic
assemblies. This material can be used on
energized equipment, is fast drying and has
excellent solvency for oil, grease, dirt.
Rapidly cleans dirt, oils, carbon, grease and
other contaminants
Nonflammable
Excellent material compatibility
Displaces moisture
Evaporates fast
Leaves no residues
Enhances electrical signal
Low toxicity
Available with All-Way Spray valve
TYPICAL APPLICATIONS
Pow-R-Wash Delta effectively cleans and
degreases:
Printed Circuit Boards
Circuit Breakers
Electrical Motors
Potentiometers
Contacts and Relays
Motors and Generators
Selector Switches
Solenoids
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
COMPATIBILITY
Pow-R-Wash Delta has excellent compatibility
with most materials used in the electronics
industry. With any cleaning agent, compatibility
with substrate should be determined on a noncritical area prior to use.
Material
Compatibility
ABS
Not Recommended
Buna-N
Not recommended
EPDM
Good
Graphite
Excellent
HDPE
Good
Kynar
Good
LDPE
Good
Lexan
Good
Neoprene
Good
Noryl
Good
Nylon 66
Excellent
Cross-Linked PE
Good
Polypropylene
Good
Polystyrene
Not Recommended
PVC
Excellent
Silicone Rubber
Good
Teflon
Good
Viton
Not Recommended
Performance
Grease & Lubricating Oil Removal per gram
solvent (mg)
Pow-R-Wash Delta
12.4.823.8
AK225-based Cleaner
8.4.5
ENVIRONMENTAL IMPACT DATA
HCFC-141b
HCFC-225
0.0%
0.0%
HFC
nPB
49%
0.0%
DISTRIBUTED BY:
USAGE INSTRUCTIONS
For commercial use only.
Read MSDS carefully prior to use.
Spray 4-6 inches from surface to clean. Wash
parts from top to bottom, allowing the liquid to
flush away dirt and dissolved oil and grease. For
precise application use attached extension tube.
AVAILABILITY
DEL1681 12 oz. Aerosol
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your technical and application related
questions. The toll free number is: 1-800-
TECH-401.
HCFC-225, HCFC-141b, HFC, and nPB percentages shown are the content by
weight. HCFC-225, HCFC-141b, HFC, and nPB percentages shown are the
content by weight. Hydrochlorofluorocarbons (HCFCs) are regulated under
the Montreal Protocol as Class II ozone depleting substances. HCFC-141b is
no longer produced in the US under this legislation. HCFC-225 is phased out
for production as of 2015. Hydrofluorocarbons (HFCs) are not currently
regulated.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly.
CHEMTRONICS does not guarantee the accuracy of
the data and assumes no liability in connection with
damages incurred while using it.
Chemtronics is a registered trademark of Chemtronics. All
rights reserved. Pow-R-Wash is a trademark of Chemtronics.
All rights reserved.
All other trademarks herein are trademarks or registered
trademarks of their respective owners.
Loading...