Chemglass CG-1949 User Manual

3800 N. Mill Road

A

H

C D B

Leveling Feet

Vineland, NJ 08360

Phone: [phone]

Fax: [phone]

CG-1949 Benchtop Support Stand Instruction Sheet

Each Kit Contains The Following:
# Qty Description

A 1 Flask/Reactor Support Frame with Single Reactor Base Plate
B 2 S.S. Uprights
C 2 Crossbar for Reactor/Motor Support
D 2 Reactor Support Rod for 1000mL to 5L
E 1 Reactor Support Rod for 250mL to 1000mL, Velcro
F 1 60mm ID Cork Ring, Fits 250mL Reactor
G 1 90mm ID Cork Ring, Fits 300mL to 1000mL, Reactor
H 1 120mm ID Cork Ring, Fits 2L to 5L Reactor
I 1 250mL Adapter Plate
J 1 300mL - 1000mL Adapter Plate

Assembly Instructions:

1. With the stand A in the upright

position, install the uprights B by sliding
the S.S. pipe through the top of the
fittings in the base. Tighten the Allen
screws. Note: Leveling feet will be at
the bottom and are adjustable.

2. Slide both crossbars C over the
uprights and position as shown on the
diagram. The red knobs should be on
the bottom. Tighten the black knobs
on each end to hold them in place.
The positions will have to be adjusted
depending on the glassware and
motor used in the support stand.

3. Install the support rod(s) D or E, cork
ring F, G, or H and adapter plate I or J
that corresponds with the reactor size
that you are using.

www.cglifesciences.com [e-mail]