Cheetah A183 User Manual

A183

3W USB Dancing Water Speakers

User Manual

Please retain for future reference

2 Ver 1 02/2015

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the user of the product for future reference.
Before use please inspect the product for any signs of damage. If the product is damaged, DO NOT use
it, and contact your supplier immediately.

OPERATING INSTRUCTIONS

1. Place the speakers on a clean, level surface.

2. One of the speakers has a fixed lead on the rear. Connect the end of this lead into the USB port on
the rear of the second speaker (see fig. 1)

3. Connect the larger end of the supplied USB lead to a spare USB port on your computer (see fig. 2) If

you want to power the speakers via a USB adaptor please ensure the adaptor has a minimum
output of 1A.

Connect the smaller end of the lead to the USB POWER port on the first speaker (see fig. 3) The unit

will illuminate and the water will jump once. The USB lead only provides power to the speakers,

NOT audio. A jack lead must be connected for audio use.

4. Connect one end of the supplied jack lead to the AUDIO IN port on the first speaker. (see fig. 4)
Connect the other end to the headphone output on your computer (see fig. 5)

5. Your USB Dancing Water Speakers are now ready to use.

fig. 1 fig. 2 fig. 3

fig. 4 fig. 5