Checkpoint Systems TR7240 User Manual

10068416

NOTICE TO PERSONS RECEIVING THIS DRAWING

Title:

USER’S MANUAL

TR7240 TX/RX

AND/OR TECHNICAL INFORMATION:

Checkpoint Systems claims proprietary rights to the material disclosed hereon.
This drawing and/or technical information is issued in confidence for
engineering information only and may not be reproduced or used to manufacture
anything shown or referred to hereon without direct written permission
from Checkpoint Systems to the user. This drawing and/or technical information
is the property of Checkpoint Systems and is loaned for mutual
assistance, to be returned when its purpose has been served

THIS DRAWING AND/OR TECHNICAL INFORMATION IS THE
PROPERTY OF CHECKPOINT SYSTEMS, INC.

.

REVISIONS

REV DESCRIPTION DATE ENGINEER REV DESCRIPTION DATE APPROVED

00 TBD 10/30/13

P. VACHRANUKUNKIET

REVISIONS

10077443

Used On

DOC SPEC

DWN

CHK

ENG

P. VACHRANUKUNKIET

APPD

Size A

Scale: N/A

10068416

 Checkpoint Systems, Inc. 2013

11T

Page 1 of 31

TR7240User Manual Rev.00

1 of 10

Important Information to our Users in North America

FCC Regulatory Compliance Statement

Checkpoint Systems, Inc., offers Electronic Article Surveillance (EAS) or Radio Frequency Identification Products
that have been FCC certified or verified to 47 CFR Part 15 Subparts B/C. Appropriately, one of the following labels
will apply to the approval:

NOTE: This equipment has been tested and found compliant within the limits for a class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at own expense.

- OR -

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) including this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation, which
may include intermittent decreases in detection and/or intermittent increases in alarm activity.

Industry Canada Regulatory Compliance Statement

This device complies with the Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may cause undesired operation of the
device.

Le fonctionnement de l’ appareil est soumis aux deux conditions suivantes:

(1) Cet appareil ne doit pas perturber les communications radio, et
(2) cet appareil doit supporter toute perturbation, y compris les perturbations qui pourraient provoquer son

dysfonctionnement.

Checkpoint’s Electronic Article Surveillance (EAS) products have been designed for safeness during normal use
and, where applicable have been certified, listed, or recognized in accordance with one or more of the following
safety standards; UL 60950-1, CSA C22.2 No. 60950-1-07. Additional approvals may be pending.
WARNING: Changes or modifications to Checkpoint’s EAS equipment not expressly approved by the party
responsible for assuring compliance could void the user’s authority to operate the equipment in a safe or otherwise
regulatory compliant manner.

Equipment Compliance Statement

WARNING: Changes or modifications to Checkpoint’s EAS or Radio Frequency Identification (RFID) equipment not
expressly approved by the party responsible for assuring compliance could void the user’s authority to operate the
equipment in a safe or otherwise regulatory compliant manner.

Equipment Safety Compliance Statement

Important Information to our Users in Europe

CE Regulatory Compliance Statement

Where applicable, Checkpoint Systems, Inc. offers certain Electronic Article Surveillance (EAS) products
that have CE Declarations of Conformity according to R&TTE Directive 99/5/EC, EMC Directive
2004/108/EC, and Low Voltage Directive 2006/95/EC.

System Electromagnetic Compatibility (EMC) has been tested and notified through Spectrum Management
Authorities if necessary, using accredited laboratories, whereby, conformity is declared by voluntarily
accepted European Telecommunications Standards Institute (ETSI) standards EN 301489-3 and EN
302208 and/or EN 300330, as applicable.

NOTE: Certain Electronic Article Surveillance (EAS) equipment have been tested and
found to conform to the CE emission and immunity requirement in Europe. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Under unusual circumstances, interference from external sources may
degrade the system performance, which may include intermittent decreases in detection
and/or intermittent increases in alarm activity. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment experiences frequent
interference from external sources or does cause harmful interference to radio
communications reception, which can be determined by turning the equipment off and on,
please contact a Checkpoint Systems representative for further assistance.

RoHS Compliance Statement

The RoHS Directive stands for "the restriction of the use of certain hazardous substances in electrical and
electronic equipment." A RoHS compliant product means that electrical and electronic equipment cannot
contain more than maximum permitted levels of lead, cadmium, mercury, hexavalent chromium,
polybrominated biphenyl (PBB) and polybrominated diphenyl ether (PBDE). Checkpoint is in compliance
with the RoHS directive.

WEEE Compliance Statement

The Waste Electrical and Electronic Equipment Directive (WEEE) applies to companies that
manufacture, sell, distribute, or treat electrical and electronic equipment in the European Union. There
are a number of obligations imposed on Checkpoint as a supplier of electrical and electronic
equipment. Checkpoint's compliance approach for each of these obligations is provided below.

TR7240User Manual Rev.00

3 of 10