Certification Exhibit
FCC ID: YWZ-S3I0007
IC: 3356F-S3I0007
FCC Rule Part: 15.247
IC Radio Standards Specification: RSS-210
ACS Project Number: 15-0129
Manufacturer: Alpha - High Theft Solutions, A Division of Checkpoint
Systems, Inc.
Model: S3I-0007
5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598
!"#$%&'$!("#)*(%)S3I$SHELFNET$SENSOR-+),#-!.///01)
• 2)345643)78)9:;3<=)>;?)@;=A3)B;C4)@44D)E436?D4E)>7)F>)394=6F=)@5;DE)9G3B453),H1)
• I57EG=>)6D)9:;=4)3J6>=B),K1)
• IG3B45)63)9:;=4)3J6>=B),-1)
• '7LL63367D);=<7D)@GM7D),N1)
• %49:;=4;@:4)'%KN/)@;M45O)
• P/KQHRQN)@;34E)KQN)STU)5;E67)>5;D3=46C45)
• #-6)9G3B45)34D375)J75A3)6D)>;DE4L)J6>B)>B4)#-6))
)))))D4>J75A)>7)>56??45);GE67)844E@;=A)>7)>B4)G345);DE))
)))))>7)3>754)94537DD4:)
VWX)*W2$&%W#Y)
I%(Z&'$)ZW#'%!I$!("Y)
$B63)E4C6=4)=7L9:643)J6>B)I;5>)HR)78)>B4)*'')%G:43Q))(945;<7D)63)3G@[4=>)>7)>B4)87::7J6D?)>J7)=7DE6<7D3Y),H1)>B63)E4C6=4)L;O)D7>)
=;G34)B;5L8G:)6D>458454D=4);DE),K1)>B63)E4C6=4)LG3>);==49>);DO)6D>458454D=4)54=46C4E\)6D=:GE6D?)6D>458454D=4)>B;>)L;O)=;G34)
GDE43654E)7945;<7DQ))*'')!ZY)X]^.#-!//0\)!'Y)--R_*.#-!//0)
• $B4)>;?)J6::)[76D);DO));C;6:;@:4)#-6)D4>J75A);DE)=B4=A)6D)J6>B6D)>B4)34>)6D>45C;:),E48;G:>Y)-)L6DG>431)
• $B4)>;?)J6::)=7LLGD6=;>4)3>;>G3)=B;D?4)>7)>B4))957EG=>)6D)9:;=4)3J6>=B)75)>B4)9G3B45)6D)9:;=4)3J6>=B)
• ]B4D)>B4)=7LL63367D);=<7D)@GM7D)63))954334E)EG56D?)>B4)=B4=A.6D)957=433)>B4)E4C6=4)J6::)54975>)
=G554D>)3>;>G3),@;M45O)C7:>;?4\)3J6>=B)3>;>43)4>=QQ1);3)J4::);3)54=46C4)=7LL;DE3)857L)>B4)D4>J75A)
• Z;3B@7;5E3);DE);:45>3);54)?4D45;>4E)>7)3B7J)=7L9:6;D=4\)34=G56>O)@54;=B43);DE)6DC4D>75O):4C4:3)
,H1)
,-1)
,K1)
,N1)
#-6)#B4:8D4>)#4D375)
=7LLGD6=;>43)>B57G?B)>B4)
#-6)D4>J75A)
"7<F=;<7D3);DE)54975>3);54)?4D45;>4E)@;34E)7D)>B4)
;=<C6>O)54975>4E)@O)>B4)#-6)#B4:8D4>)#4D375)
Alpha High Theft Solutions S3I-0007
Warning: Changes or modifications to this device not expressly approved by Alpha could void the user’s
authority to operate the equipment.
FCC Information and Compliance
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
For Class A Devices:
“NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.“
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le
but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type
d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité
nécessaire à l’établissement d’une communication satisfaisante.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Loading...