Checkpoint Systems NANOGATEAM User Manual

IC Radio Standards Specification: RSS-210

Manufacturer: Alpha - High Theft Solutions

Certification Exhibit

FCC ID: YWZ-NANOGATEAM

IC: 3356F-NANOGATEAM

FCC Rule Part: 15.209

ACS Project Number: 12-0033

Model: NANOGATE-AM

Manual

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: [phone]

Pressure
Switch

Annunciator

LED

Pivoting Antenna

Diagram 1

1.83 m

.91 m

(3’)

(6’)

1.06 m

(3.5’)

Instructions for the Nano Gate

NANOGATE-AM

TOOLS SUPPLIED:

• (1) Nano Gate - AM

• (1) Mounting Template

• (2) Brackets

• (4) P-Clips with Screws

• (10) Metal Screws

• (2) Caps

• (1) AC Power Cord - .6 m (2’) L

TOOLS REQUIRED:

• Electric Hand Drill

• 1/8” Drill Bit

• Phillips PH0 Screw
Driver

• Tape Measure

• Tape

Clear Antenna

Pivoting Antenna

FACTS ABOUT THE NANO GATE:

1. The Nano Gate can be installed on any at surface.

2. The Nano Gate can be installed with Power Cord up

or down.

3. The Nano Gate triggers 3 Alarm AM devices.

4. The red light indicates good power and serves as a

visual deterrent.

5. The Nano Gate can pivot side-to-side if bumped into.

6. The Nano Gate will alarm continuously if the
Pressure Switch comes off the wall.

NOTE: If power is removed, the Nano Gate will chirp
for 2 minutes.

7. The Nano Gate should not be placed within
4m (13’) of EAS systems

INSTALLATION:

1. Place the provided Mounting Template onto a at surface with tape. The Mounting Template will be marked with
TOP and BOTTOM for placement and provides where the holes need to be drilled.

NOTE: Must mount Nano Gate at least 0.91 m (3 feet) from oor

2. Drill 6 holes as indicated on the template. (Fig. 1)

3. Remove the template. You should have 3 holes on top and 3 holes on bottom.

4. Screw bottom bracket in place with 3 screws. (Fig. 2)

5. Screw in the top screw only - allowing space for the Bracket to slide. (Fig. 3)

6. Insert bottom end of the Nano Gate into the bottom Bracket. (Fig. 4)

7. Push the top Bracket down onto the Nano Gate. (Fig. 5)

Screw remaining screws into top Bracket. (Fig. 6)

8. Plug power supply cord in power box and wind extra cable into storage box. Mount storage box. (Fig. 7)
Place the Caps on the top and bottom end of the Nano Gate and screw in with the 4 small screws provided. (Fig. 8)

NOTE: Once the Nano Gate is ush to the wall the unit will chirp to indicate the Pressure Switch is engaged and the unit is armed.

9. The Nano Gate is now installed. (Fig. 9)

NOTE: 1.83 m (6’) coverage requires mounting Nano Gate in off-set locations on the door. (See Diagram 1)

www.alphaworld.com