Checkers Linebacker Extra Heavy Duty Cable Ramps User Manual

EXTRA HEAVY DUTY

HD

2, 3, 4, or 5 CHANNEL SYSTEMS

ASSEMBLY INSTRUCTIONS

ASSEMBLY:

• Inspect areas for safety hazards

• Assemble sections by aligning female connectors over male connectors

• Press with foot to secure female connectors to male connectors

• Open cover and install cables down into channels

• Close cover flush with base

• Test installation for intended use

• Periodically inspect installation

CABLE/HOSE MANAGEMENT COMPONENTS

Simply interlock with
T-connectors to extend
protection length.

36" Lineal ProtectorEnd Cap End Cap 45˚ Left Turn 45˚ Right Turn

CHANNEL CAPACITY:

5 Channel

4 Channel

3 Channel

2 Channel

CHANNEL CAPACITY - MAX. DIAMETER INCHES (mm)

End Caps (2)

End Caps (2)

End Caps (2)

N/A

45˚ Left Turn

45˚ Left Turn

45˚ Left Turn

N/A

LOAD CAPACITY:

The Cable/Hose Protection System has
different load supporting capabilities
depending on type of vehicle and
temperature. Suitability must be verified
by testing under actual conditions.

NO. OF

CHANNELS

5 Channel

4 Channel

3 Channel

2 Channel

MAXIMUM LOAD PER TIRE

70˚F (21˚C)

20,150 lbs. (9,140 kg)

20,150 lbs. (9,140 kg)

14,210 lbs. (6,446 kg)

10,880 lbs. (4,935 kg)

OPERATING TEMPERATURE:

-40˚F to 120˚F (-40˚C to 48˚C)

CHEMICAL RESISTANCE:

Tested for compatibility with common motor oils, gasoline and diesel fuel.
Limited resistance to brake fluids and other chemicals.

45˚ Right Turn

45˚ Right Turn

45˚ Right Turn

N/A

MAXIMUM LOAD PER AXLE

1.25 in. (31.8 mm)

1.25 in. (31.8 mm)

2.25 in. (57.2 mm)

3.25 in. (82.6 mm)

70˚F (21˚C)

40,300 lbs. (18,280 kg)

40,300 lbs. (18,280 kg)

28,420 lbs. (12,892 kg)

21,760 lbs. (9,870 kg)

MATERIAL:

UV-stabilized polyurethane elastomer

#ZIS-HD

Ver: 2/11

EXTRA HEAVY DUTY

HD

CABLE AND HOSE MANAGEMENT SYSTEM INSTALLATION INSTRUCTIONS

LINEBACKER® HD is a cable/hose management system intended to reduce the possibility of damage to cables and hose
lines that are subject to pedestrian and vehicular traffic. It is intended for temporary installations only and must be in
accordance with all applicable electrical, building and safety codes. DO NOT use connectors or splices within this system.

2, 3, 4, or 5 CHANNEL SYSTEMS

CAUTION: MISUSE CAN CAUSE ELECTRICAL SHOCK AND INJURY

• DO NOT use as work surface. NO CUTTING, NO DRILLING, NO HAMMERING.

• Use with momentary loads only, DO NOT place ladders, scaffolds, or any type of structure on the system.

• Avoid concentrated loads.

• Use only on a stable surface. Inclined surfaces, slippery surfaces and broken ground can cause injury.

• This system can be a trip hazard to pedestrian traffic if they are unaware of its presence.

• Keep the LINEBACKER cable/hose management system clean and bright.

• Load-supporting capacity varies by type of loading conditions and environmental conditions. The load capacity values

are listed in the "operating parameters". The load capacity decreased in warm environments. Test before use and
inspect periodically.

• Keep various services, communications, fluids and power separated. Limit a channel to one service type.

• Polyurethane is attacked by some chemicals. Always test a small amount for chemical compatibility before using and

follow maintenance procedure.

• Vehicular traffic must pass over this system slowly and with caution.

MAINTENANCE

• Store in a clean dry area.

• Inspect system for damage and replace it if damaged. Remove any foreign materials, solids and liquids. Keep clean by

using a detergent and water solution.

WARRANTY AND LIABILITY

LIMITED WARRANTY: Checkers guarantees the products it manufactures or sells against defects in workmanship and material for a period of one (1) year
from the date of shipment or date of invoice, whichever is later. The product must be used, maintained and installed according to the instructions and
procedures provided, or this warranty is void. Any alteration or modification of the product will also void this warranty. CHECKERS’ OBLIGATION UNDER THIS
WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS. No other warranty or remedy shall be provided. This warranty

specifically does not guarantee or cover payment or reimbursement of any damages or consequential damages beyond the above.

Any claim under this warranty must be made in writing within twelve (12) months of the date of shipment or the date of invoice, whichever is later. All products
returned to Checkers under this warranty must be prepaid. If it is determined that the product is defective in material and /or workmanship the repair or
replacement will occur, at Checkers’ option, at no charge and return freight prepaid by Checkers. All other return of product to the owner shall be at the
owner’s expense.

CHECKERS AND ITS AUTHORIZED AGENTS, EMPLOYEES AND REPRESENTATIVES SPECIFICALLY AND EXPRESSLY DISCLAIM ANY AND ALL OTHER
WARRANTIES, INCLUDING THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY WARRANTY OF MERCHANTABILITY WHICH
MIGHT OTHERWISE BE APPLICABLE UNDER ANY STATE OR FEDERAL LAW.

LIMITED LIABILITY OF CHECKERS: Checkers and its authorized agents, distributors and representatives do not guarantee the performance of any Checkers
product in the customer’s use as the manufacturer is unable to assure proper use by the customer. Proper use by the customer is necessary for the effectiveness

of the product, as well as the safety of those using same. The user is solely responsible to determine the suitability of any Checkers product for any intended use.
The user assumes all risk and liability for use of any Checkers product.

User specifically acknowledges receipt of proper instructions regarding the use of the product in the original packaging and disclaims any consequential

damages to person or property, damages for loss of use, lost time, loss of profit, lost income, loss of the Checkers’ product itself and/or other incidental or

consequential damages other than as warranted by Checkers limited warranty. User accepts the responsibility of removing from service any product that
becomes worn out, unusable, unfit for intended use or defective in any way such as to make the product a potential safety hazard. Checkers is unable to

undertake such obligations or responsibilities on behalf of the user as the user is in sole possession and control of the product.

© 2011 Checkers Industrial Safety Products

#ZIS-HD

Ver: 2/11

www.checkersindustrial.com

620 COMPTON ST • BROOMFIELD, CO 80020 • PH: 720-890-1187 • FAX: [phone] • TOLL FREE: 800-438-9336