GORILLA® ALL PURPOSE WARNING WHIPS
Patent Pending
From the Experts in Industrial Safety
INSTALLATION INSTRUCTIONS
1
3
2
3
1. Remove jam nut and lock washer from hex base
2. Attach hex base directly to vehicle or bracket
using lock washer and jam nut. Requires 1/2”
mounting hole.
3. Strip yellow jacket from hot plug with pigtail to
desired length
4. Strip the insulation from each conductor to
desired length. Please note that the white wire
with black strip is the hot wire and the white wire
is the ground wire.
5. Use wire connectors of your choice to attach to
your desired power supply.
Ver: ALLPWINST-3/14
4
620 COMPTON ST • BROOMFIELD, COLOR ADO, USA 80020
800-438-9336 • www.checkersindustrial.com
GORILLA® ALL PURPOSE WARNING WHIPS
Patent Pending
From the Experts in Industrial Safety
PROGRAMMING INSTRUCTIONS
1
2
3
2
2
4
1. Remove the clear lens
from the base by turning
counterclockwise
2. With the light powered on,
hold the remote close to
the sensor. You may need
to block the light emitting
from the LED’s to enhance
the communication from the
remote to the light.
3. Use the + and - buttons on
the remote to select the flash
pattern desired (see chart)
4. Afer the flash pattern has
been selected, turn the clear
lens clockwise on to the
upper base
00 .5 11 .5 22 .5 33 .5 4
20
0
20
0
20
0
20
0
20
0
20
0
INTENSITY (Joules)
20
0
20
0
20
0
TIME (Seconds)
620 COMPTON ST • BROOMFIELD, COLOR ADO, USA 80020
800-438-9336 • www.checkersindustrial.com
#
1 - Breathe followed by
16 Stockato Flashes
#
2 - Rapid Flash
#
3 - Brighten then Flash
#
4 - Breathe then Flash
#
5 - Slow Blink
#
6 - Flash
#
7 - Steady
#
8 - Increasing Sequential
Blinks
#
9 - Off
Loading...