Chauvet Pro Ovation F-265WW Quick Start Guide

Quick Reference Guide

English EN Español ES Français FR Nederlands NL

QUICK REFERENCE GUIDE

About This Guide

The Ovation F-265WW Quick Reference Guide (QRG) has basic product information such as connection, mounting, menu options, and DMX values. Download the User Manual from www.chauvetprofessional.com

Disclaimer

The information and specifications contained in this QRG are subject to change without notice.

Safety Notes

These Safety Notes include important information about installation, use, and maintenance.

• DO NOT open this product. It contains no user-serviceable parts.

• DO NOT look at the light source when the product is on.

• To eliminate unnecessary wear and improve its lifespan, during peri ods of non-use completely disconnect the product from power via breaker or by unplugging it.

• CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to warm humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure, allow product to fully acclimate to the surrounding environment before connecting it to power.

• CAUTION: This product’s housing may be hot when lights are operating.

• Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.

• DO NOT leave any flammable material within 50 cm of this product while operating or connected to power.

• USE a safety cable when mounting this product overhead.

• DO NOT operate this product outdoors or in any location where dust, excessive heat, water, or humidity may affect it. (IP20)

• DO NOT operate this product if the housing, lenses, or cables appear damaged.

• DO NOT connect this product to a dimmer or rheostat.

• ONLY connect this product to a grounded and protected circuit.

• ONLY use the hanging/mounting bracket or the handles to carry this product.

• In the event of a serious operating problem, stop using immediately.

• The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.

Contact

Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux contact your distributor to request support or return a product. Visit www.chauvetprofessional.com for contact information.

What is Included

• Ovation F-265WW

• Neutrik® powerCON® power cord

• Gel Frame

• Warranty Card

• Quick Reference Guide

AC Power

This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.

Power Linking

You can link up to 7 Ovation F-265WW products at 120 V, 12 products at 208 V, or 13 products at 230 V. Never exceed this number. Powe r linking cords can be purchased separately.

AC Plug

Connection Wire (U.S.) Wire (Europe) Screw Color

AC Live Black Brown Yellow/Brass AC Neutral White Blue Silver AC Ground Green/Yellow Green/Yellow Green

for more details.

To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the product from power via breaker or by unplugging it.

Ovation F-265WW QRG Rev. 2

QUICK REFERENCE GUIDE

Safety Cable

Mounting Clamp

Secure the safety

cable using the passageway on

the back of the

product

Replacing the Fuse

1. Disconnect this product from power.

2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.

3. Remove blown fuse and replace with a good fuse of the same type and rating.

4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The Ovation F-265WW will work with a DMX controller using a 3- or 5-pin DMX data connection. A DMX Primer is available from www.chauvetprofessional.com

DMX Connection

The Ovation F-265WW uses a 3- or 5-pin DMX data connection for its DMX personalities: 1Ch: 8bit Dim, 2Ch: 16bit Dim, 2Ch: 8bit Dim+Zoom, and 5Ch: 16bit-Full. See the User Manual for information about co nnecting and con figuring

the product for DMX operation.

Master/Slave Connection

The Ovation F-265WW uses the DMX data connection for its Master/Slave mode. See the User Manual for information about connect and configure the product for master/slave operation.

RDM (Remote Device Management)

Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally along existing DMX cabling. The Ovation F-265WW suppor ts RDM pr otocol that allows fee dba ck to monitor temper ature and changes to DMX Address, DMX Personality, Dimmer Mode, and LED Frequency menu options. Download the User Manual from www.chauvetprofessional.com

Mounting

Before mounting this product, read the Safety Notes. Use at least one mounting point per product. Make sure the mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products

Mounting Diagram

for more details.

Ovation F-265WW QRG Rev. 2

QUICK REFERENCE GUIDE

Control Panel Description

Button/Knob Function

<MENU> Exits from the current menu or function

<ENTER> Enables the currently displayed menu or sets the currently selected value into the selected function

<UP> Navigates upwards through the menu list and increases the numeric value when in a function

<DOWN> Navigates downwards through the menu list and decreases the numeric value when in a function <KNOB1> Push then turn to increase or decrease the dimmer <KNOB2> Push then turn to increase or decrease the zoom

Menu Map

Main Level Programming Levels Description

DMX Address 001–512

1Ch: 8bit Dim 1-channel: 8-bit dimmer

DMX

Personality

Static

Master/Slave

Dimmer

Mode

LED

Frequency

Fan Mode

Back Light

Fixture Hours <_ _ _ _H> Shows total hours the product has been powered on

Information

Reset

Factory

2Ch: 16bit Dim 2-channel: 16-bit dimmer

2Ch: 8bit Dim+Zoom 2-channel: 8-bit dimmer, zoom

5Ch: 16bit-Full 5-channel: 16-bit dimmer, zoom, strobe, motor reset

Dimmer 0–255 Controls intensity

Zoom 0–255 Controls zoom

Strobe 0–255 Controls strobe rate

Master DMX mode (Master)

Slave Slave mode

Off Linear dimmer

Dimmer 1–3 Dimming curves Dimmer 1 (fast) to Dimmer 3 (slow)

600Hz 1200Hz 2000Hz 4000Hz 6000Hz

25KHz

Auto Sets the fan to auto mode

On Sets the fan to always on Off Turns the fan off

On Display backlight always on 10S Turns off display backlight after 10 seconds of inactivity 20S Turns off display backlight after 20 seconds of inactivity 30S Turns off display backlight after 30 seconds of inactivity

Version <V_._> Shows current firmware version

UID <_ _ _ _ _ _ _ _> Shows product UID

No Yes

Selects DMX address (highest channel restricted to personality chosen)

Sets the PWM frequency

Resets the product to factory default settings

Ovation F-265WW QRG Rev. 2

QUICK REFERENCE GUIDE

DMX Values

5Ch: 16bit-Full

Channel Function Value Percent/Setting

1 Dimmer 000 2 Dimmer Fine 000 3 Zoom 000

4Strobe

5 Motor Reset

2Ch: 8bit Dim+Zoom

Channel Function Value Percent/Setting

1 Dimmer 000 2 Zoom 000

255 0–100% 255 0–100% 255 0–100% 009 Open

000 010

099 Strobe, slow to fast

100

109 Open

110

179 Lightning effect, slow to fast

180

189 Open

190

255 Random strobe, slow to fast

000

200 No function

201

220 Motor reset

221

255 No function

255 0–100% 255 0–100%

2Ch: 16bit Dim

Channel Function Value Percent/Setting

1 Dimmer 000 2 Dimmer Fine 000

255 0–100% 255 0–100%

1Ch: 8bit Dim

Channel Function Value Percent/Setting

1 Dimmer 000

255 0–100%

Ovation F-265WW QRG Rev. 2

GUÍA DE REFERENCIA RÁPIDA

Acerca de Esta Guía

La Guía de Referencia Rápida (GRR) del Ovation F-265WW contiene información básica sobre el producto, como montaje, opciones de menú y valores DMX. Descargue el manual de usuar io de www.chauvetprofessional.com información más detallada.

Exención de Responsabilidad

La información y especificaciones contenidas en esta GRR están sujetas a cambio sin previo aviso.

Notas de Seguridad

Estas notas de seguridad incluyen informació n imp or tant e so br e el mo n taje , us o y ma nte n imie n to .

• NO abra este producto. No contiene piezas reparables por el usuario.

• NO mire a la fuente de luz cuando el producto esté encendido.

• Para evitar un desgaste innecesario y alargar su vida útil, desconecte complemente el producto de la alimentación, mediante el interruptor o desenchufándolo, durante los periodos en los que no se use .

• Cuidado: cuando transfiera el producto desde ambientes con tem peratura extrema (p. ej., del remolque frío de un camión a una sala de baile con calor y humedad), puede formarse condensa ción en la electrónica interna del producto. Para evitar que se produzca una avería, deje que el producto se aclima t e completame nte al a mbiente antes de conectar la alimentación.

• ¡CUIDADO! La carcasa de este producto está caliente cuando las luces están en funcionamiento.

• Monte este producto en una ubicación con ventilación adecuada, al menos a 20'' (50 cm) de superficies adyacentes.

• NO deje ningún material inflamable a menos de 50 cm de este pro ducto mientras esté fun cionando o conectado a la alimentación.

• USE un cable de seguridad cuando monte este producto en lo alto.

• NO ponga en funcionamiento este producto en el exterior o en cualquier ubicación en la que el polvo, calor excesivo, agua o humedad puedan afectarlo. (IP20)

• NO ponga en funcionamiento este producto si sospecha que la carcasa, lentes o cables están dañados.

• NO conecte este producto a un atenuador o reostato.

• Conecte este producto SOLO a un circuito con toma de tierra y protegido.

• Use SOLAMENTE los soportes de colgar/montar o las asas para mover este producto.

• En caso de un problema grave de funcionamiento, deje de usarlo inmediatamente.

• La máxima temperatura ambiente es de 113 °F (45 °C). No haga funcionar este producto a temperaturas más altas.

Contacto

Fuera de EE.UU, Reino Unido, Irlanda, México o Benelux, póngase en contacto con su distribuidor para solicitar asistencia o devolver el producto. Visite www.chauvetprofessional.com

para información de contacto.

Qué va Incluido

• Ovation F-265WW

• Cable de Alimentación Neutrik® powerCON®

• Marco de gel

• Tarjeta de Garantía

• Guía de Referencia Rápida

Corriente Alterna

Este producto tiene una fuente de alimentación con detección automática que puede funcionar con un rango de tensión de entrada de 100–240 VCA, 50/60 Hz.

Alimentación en Cadena

Puede enlazar hasta 7 productos Ovation F-265WW a 120 V, 12 productos a 208 V o 13 productos a 230 V. Los cables de alimentación en cadena se pueden adquirir por separado .

Enchufe CA

Conexión Cable (EE.UU) Cable (Europa) Color del Tornillo

CA Cargado Negro Marrón Amarillo/Bronce

CA Neutro Blanco Azul Plata

CA Tierra Verde/Amarillo Verde/Amarillo Verde

para

Para evitar un desgaste innecesario y alargar su vida útil, desconecte complemente el producto de la alimentación, mediante el interruptor o desenchufándolo, durante los periodos en los que no se use.

Ovation F-265WW GRR Rev. 2

+ 14 hidden pages