Chauvet F-1250 User Manual

Troubleshooting

Troubleshooting

If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the

external fuse, remote connection and main power supply. If all appear to be OK, plug the unit in again. If

fog does not come out after holding the remote control button for 30 seconds, check the hose attached to

the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the

problem, do not simply continue to push the remote control button as this may damage the unit. Contact

CHAUVET for servicing.

Contact Chauvet

USA

Tecnical Assistance: 1-800-762-1084 [phone]

E-Mail [e-mail]

Caution

• Never remove the Fluid tank from the unit as this will damage the fluid level sensors.

• Never use any other type of liquid other than UNSCENTED water based fog fluid.

• Use of any other fluids or additives will void the warrantee

• Do not obstruct the nozzle. Fog output is very hot, avoid coming within 60cm (24”) of the nozzle during

operation. Never aim the nozzle directly at people or naked flames.

• Danger of Burns. Keep out of reach of children. Do not leave machine unattended.

• Output nozzle becomes very hot during operation (300oC). Keep flammable materials at least 50cm (20”)

away from the nozzle.

• Always allow the fogger to cool down before cleaning or servicing.

• Never drink fog liquid. If its ingested, call a doctor immediately. If fog fluid comes into contact with skin or

eyes, rinse thoroughly with water.

• Beware of condensation around the nozzle. Consider carefully when mounting.

• All fog machines may splutter small amounts of fog occasionally during operation and for a minute or so

after being turned off.

• Never place the fog machine on any flammable material (i.e. carpet, fabric etc.) during operation. All fog

machines generate a considerable amount of heat. When placed on the floor, fog machines should always

be placed on a non-flammable surface such as concrete or tile.

• Depending on the amount of fog generated, all fog machines may set off smoke detectors.

Power Connections

The unit is supplied with a power plug appropriate to its voltage and destination. Should any other

connections be required they must be carried out with the following configuration.

Earth = Green/Yellow cable

Neutral = Blue cable

Live = Brown cable

In the USA & Europe, it is required that all plugs are 3-pin type i.e. with Earth/Ground connection.

In the UK, it is required that all mains plugs are fitted with 5A fuses.

Technical Specifications

Technical Specifications

Power Input:

AC 120V 60 Hz or 230V 50 Hz

Fog Output:

10,000 Cubic Feet per Minute

Fuse:

10A 125V or 5A 250V

Tank Capacity:

3.5 Liter

Dim:

20.5 x 7.9 x 8 in

Size

520 x 200 x 203mm

Weight:

17 lbs / 7.7 Kg

User Informtion

(Please complete for your records)

Date Purchased: / /

Serial No: ________________

Dealer Stamp

Model: F-1250 Fog Machine

Hollywood, Florida, USA 33020

www.ChauvetLighting.com

yellow indicator light will come on. Adjust the duration and interval knobs to achieve the desired effect. The

the bracket provided. Ensuring that the fog is not shooting directly at anyone’s face. Whatever method of

will also find this listed as part of the specifications for the unit later in this guide. It is most important that

the main power supply to check. If the unit is still not working then please contact CHAUVET.

with white vinegar and a pipe cleaner, making sure that the hole is free and unobstructed.

which it vaporizes. However a well maintained machine should provide years of reliable use.

this will damage the fluid level sensors.

there is sufficient fluid. The red L.E.D.’s will flash when the fluid needs replenishing. In order to increase

the life of the F-1250, the unit will not fog when the red L.E.D.’s are flashing. This feature of Chauvet’s will

the unit and the remote will illuminate when the unit is ready for action again.