Chauvet b50 User Manual

™

Quick Reference Guide

Lil’ Bubbler

B-50 Lil’ Bubbler™ QRG

About This

Guide

• This Quick Reference Guide DOES NOT replace the product’s User

These Safety Notes includ e important safety information about installation,

machine or any moving part.

The Lil’ Bubbler Quick Reference Guide (QRG) only contains the
product’s connection, mounting, and operation information.

Manual, which you can download from th e CHAUVE T ® we b site:

www.chauvetlighting.com.

Disclaimer

• Read ALL the disclaimers and safety notes in this document as well as

those in the product’s User Manual before insta l li ng , ope ra t ing, or
maintaining this product.

Safety Notes

usage, and maintenance.

• Always connect this product to a grounded circuit to avoid the risk of

electrocution.

• Always disconnect from the power source before cleaning this product.

• Never disconnect this product from power cord by pulling or tugging

on the cord.

• If mounting this product overhead, always secure it to a fastening

device using a safety cable.

• Do not mount this product on a flammable surface.

• Do not drink the bubble fluid. If you do, call your local emergency

service (911) for help.

• Do not add perfume, alcohol, gasoline, or other flammables to the fluid.

• Do not obstruct the bubble wands or allow children to play with the

• Make sure the voltage of the outlet to which you are connecting is

within the range stated on the decal or rear panel of th e product.

• This product is for indoor use only! (IP20) To prevent risk of fire or

shock, do not expose this product to rain or moisture.

• Always install this product in a location with adequate ventilation, at

least 20 in (50 cm) from adjacent surfaces.

• Do not obstruct the bubble wands or leave machine unattended.

• Never carry this product from the power cord.

• Do not overfill; spillage may occur. Always mount on a flat, level

surface.

• Do not leave unused fluid in the reservoir for an extended period. The

fluid may thicken in the reservoir.

• In the event of a serious operating problem, stop using the unit

immediately.

• Never try to repair this product. Repairs performed by unauthorized

technicians can lead to damage or malfunction. Pleas e contact the
nearest authorized t echnical assistance center.

Page 2 of 4

B-50 Lil’ Bubbler™ QRG

What Is

Included

AC Power

This product has a voltage-specific power supply that can work with an

Weight: 3.7 lbs (1.65 kg)

Set Up

Place unit on a flat, level surface or use the mountin g brackets provided.

Fuse

1. Disconnect this product from the power outlet.

4. Screw the fuse holder cap back into place and reconnect power.

Fluid Tank Access

Fan (Rear

Panel)

• Lil’ Bubbler

• Fluid Tank

• Warranty Card

• Quick Reference Guide

input voltage of 120 VAC, 60 Hz (U.S.) or 230 VAC, 50 Hz (UK).

Bubble Wands

Product Overview

Dimensions: 10.8 x 6.5 x 6.7 in (274 x 165 x 170 mm)

Handle (Top)

Fuse holder

(Rear Panel)

Ensure that the bubbles are not shooting directly in anyone’s face or above
heavy traffic areas, as bubble fluid leaves a slippery surface.

The bubble machine must not have more than a 5º angle of inclination. Do
not tilt the bubble machine or the fluid will spill.

Replacement

2. With a Phillips #2 head screwdriver, unscrew the fuse holder cap from

the housing.

3. Remove the blown fuse and replace with a good fuse of the same type

and rating (F1A, 250 V).

Page 3 of 4

B-50 Lil’ Bubbler™ QRG

Operation

Contact Us

World Headquarters

United Kingdom and Ireland

Fax: [phone]

Technical Support

Technical Support

World Wide Web

www.chauvetlighting.com

World Wide Web

www.chauvetlighting.co.uk

Outside the U.S., United Kingdom, or Ireland, contact your distributor of

1. Place the Lil’ Bubbler™ on a level surface and remove the thumbscrew

on the front of the unit for fluid tank access. Lift the cover.

2. Fill the tank with bubble fluid.

Note: CHAUVET® bubble fluid (BJU) is specially formulated for
use with CH AUVET bubble machines.

3. Lower the cover and re-tighten screw.

4. Plug into a suitable wall outlet.

5. Turn on the bubbler.

Note: Do not leave unused fluid in the reservoir for an extended
period. The fluid may thicken.

CHAUVET®

General Information

Address: 5200 NW 108th Avenue
Sunrise, FL 33351
Voice: [phone]
Fax: [phone]
Toll free: [phone]

Voice: [phone] (Press 4)
Fax: [phone]
Email: [e-mail]

record (see the CHAUVET® website). Follow their instructions to request
support or to retur n a product.

Lil’ Bubbler™ QRG – Rev. 2
© Copyright 2012 CHAUVET®

All rights reserved
Printed in the P. R. C.

Page 4 of 4

CHAUVET® Europ e Ltd.

General Information

Address: Unit 1C
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice: [phone]

Email: [e-mail]