Charmglow 730-0230 Owner's Manual
STAINLESS STEEL GAS GRILL
`
USE AND CARE GUIDE
MODEL NO.: 730-0230
RR
R
R
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE.
FOR OUTDOOR USE ONLY
TABLE OF CONTENT
SECTION ONE
Importance………………………….………….. 1
Precautions…………………………. ………. 2-3
Placement of the grill……………….……….….3
SECTION TWO
Screw description……………………………….4
Assembly Instructions……………………… 5-10
Installation of the hose onto the NG regulator…11
Your gas grill is ready to use…………………..12
Gas hook up……………………………………13
Leak testing……………………………. ……. 13
Installer final checklist………………………... 14
Operating Instructions…………………………15
Lighting Instructions……………………… 15-16
Using the side burner……………….……….... 17
SECTION THREE
Care and maintenance…………………..…17
Care and maintenance of the side burner….18
Trouble shooting………………………..…18
SECTION FOUR
Exploded View……….…………………....19
Parts List…………………………………. 20
Grilling hints…………………………….. 21
Grill cooking chart……………………. 22-24
Grill recipe suggestions………………. 25-27
SECTION FIVE
Limited Warranty……………….…………28
IMPORTANCE
* * * WARNING * * *
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid
4. If odor continues, immediately call your gas supplier or your fire department.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
1
PRECAUTIONS
WARNING
Do not try lighting this appliance without
reading the “LIGHTING INSTRUCTIONS”
section of this manual.
TESTED IN ACCORDANCE WITH ANSI
Z21.58b-2002, CGA 1.6B-2002 STANDARD
FOR OUTDOOR COOKING GAS
APPLIANCES. THIS GRILL IS FOR
OUTDOOR USE ONLY.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code ANSI
Z223.1/NFPA 54, ANSI/NFPA 58 or CSA
B149.1 Natural Gas and Propane Installation
Code, and the National Electrical Code,
ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
CALIFORNIA PROPOSITION 65WARNING
The burning of gas fuel generates some
byproducts, which are on the list of substances
which are known by the State of California to
cause cancer or reproductive harm. California
law requires businesses to warn customers of
potential exposure to such substances. To
minimize exposure to these substances, always
operate this unit according to the use and care
manual, ensuring you provide good ventilation
when cooking with gas.
SAFETY PRACTICES TO AVOID
PERSONAL INJURY
When properly cared for, your 730-0230 (Charmglow)
Grill will give safe, reliable service for many years.
However, extreme care must be used since the grill
produces intense heat and that can increase accident
potential. When using this appliance basic safety
practices must be followed, including the following:
Read this Care and Use Manual carefully and
completely before using your grill to reduce the risk
of fire, burn hazard or other injury.
Do not repair or replace any part of the grill unless
specifically recommended in this manual. All other
service should be referred to a qualified technician.
CHILDREN SHOULD NOT BE LEFT ALONE OR
UNATTENDED IN AN AREA WHERE THE GRILL
IS BEING USED. NEVER ALLOW THEM TO SIT,
STAND OR PLAY ON OR AROUND THE GRILL AT
ANY TIME.
DO NOT STORE ITEMS OF INTEREST TO
CHILDREN AROUND OR BELOW THE GRILL OR
IN THE CART. NEVER ALLOW CHILDREN TO
CRAWL INSIDE OF THE CART.
Never let clothing, pot holders or other flammable
materials come in contact with or too close to any
grate, burner or hot surface until it has cooled. Fabric
may ignite and result in personal injury.
For personal safety, wear proper apparel. Loose
fitting garments or sleeves should never be worn
while using this appliance. Some synthetic fabrics are
highly flammable and should not be worn while
cooking.
Only certain types of glass, heat-proof glass ceramic,
earthenware, or other glazed utensils are suitable for
grill use. Theses types of materials may break with
sudden temperature changes. Use only on low or
medium heat settings according to the manufacturer’s
directions.
Do not heat unopened food containers as a build-up
of pressure may cause the container to burst.
Use a covered hand when opening the grill lid. Never
lean over an open grill.
WHEN LIGHTING A BURNER, ALWAYS PAY
CLOSE ATTENTION TO WHAT YOU ARE DOING.
BE CERTAIN YOU ARE TURNING THE IGNITER
LABELED FOR THE BURNER YOU INTEND ON
USING.
2
PRECAUTIONS
When using the grill, do not touch the grill rack, burner
grate or immediate surroundings as these areas become
extremely hot and could cause burns. Use only dry
potholders. Moist or damp potholders on hot surfaces
may cause burns from steam. Do not use a towel or
bulky cloth in place or potholders. Do not let potholders
touch hot portions of the grill rack.
Grease is flammable. Let hot grease cool before
attempting to handle it. Avoid letting excess grease
deposits collect in the grease tray at the bottom of the
grill’s firebox. Clean often.
DO NOT USE ALUMINUM FOIL TO LINE THE GRILL
RACKS OR GRILL BOTTOM. This can severely upset
combustion air flow or trap excessive heat in the control
area.
For proper lighting and performance of the burners keep
the burner ports clean. It is necessary to clean them
periodically for optimum performance (see page 16). The
burners will only operate in one position and must be
mounted correctly for safe operation.
Clean the grill with caution. Avoid steam burns; do not
use a wet sponge or cloth to clean the grill while it is hot.
Some cleaners produce noxious fumes or can ignite if
applied to a hot surface.
INSECT WARNING!!! Spiders and insects can nest in
the burners of this and any other grill, and cause the
gas to flow improperly. This is a very dangerous
condition which can cause a fire to occur behind the
value panel, thereby damaging the grill and making it
unsafe to operate. Inspect the grill twice a year.
Be sure all grill controls are turned off and the grill is
cool before using any type of aerosol cleaner on or
around the grill. The chemical that produces the spraying
action could, in the presence of heat, ignite or cause
metal parts to corrode.
Do not use the grill for cooking excessively fatty meats
or products which promote flare-ups. Do not operate the
grill under unprotected combustible construction. Use
only in well ventilated areas. Do not use in buildings,
garages, sheds, breezeways or other such enclosed areas.
THIS UNIT IS FOR OUTDOOR USE ONLY.
Keep the area surrounding the grill free from
combustible materials, trash, or combustible fluids and
vapors such as gasoline or charcoal lighter fluid. Do not
obstruct the flow of combustion and ventilation air. If the
unit is stored indoors ensure that it is cool.
DO NOT USE BRIQUETTES OF ANY KIND IN THE
GRILL.
The 730-0230 (Charmglow) Grill is designed for
optimum performance without the use of briquettes. Do
not place briquettes on the radiant as this will block off
the area for the grill burners to vent. Adding briquettes
can damage ignition components and knobs, and void the
warranty.
Never use the grill in extremely windy conditions. If
located in a consistently windy area (oceanfront,
mountaintop, etc.) a windbreak will be required (see
below). Always adhere to the specified clearance.
PLACEMENT OF THE GRILL
CLEARANCE
To Non-Combustible Construction
A minimum of 24” clearance from the back of the grill to
non-combustible construction is required for the lid to
open fully.
DO NOT INSTALL THIS UNIT INTO COMBUSTIBLE
ENCLOSURES!
LOCATION
When determining a suitable location take into account
concerns such as exposure to wind, proximity to traffic
paths and keeping any gas supply lines as short as
possible. Locate the grill only in a well-ventilated area.
Never locate the grill in a building, garage, breezeway,
shed or other such enclosed areas without an approved
ventilation system. During heavy use, the grill will
produce a lot of smoke. Lock the wheels after the grill is
placed in a suitable position according to the sticker
located beneath the right door.
3
Screw description
Item
Description(SCALE 1:1)
crossed flat head screw
crossed flat head screw
double-ended screw
crossed tray head screw
Specification
1/ 4× 38mm
1/4× 12mm
φ 4× 12+3+φ 5× 12mm
Quantity
12pcs
20pcs
2pcs
× 10mm
1/4
2pcs
landfrom screw
5/32
4
× 6+φ 5× 5mm
1pcs
ASSEMBLY INSTRUCTIONS
PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP.
Attention: Please lock the caster during the process of installation of the grill.
TOOLS REQUIRED: Philips head screwdriver(not provide), Crescent wrench(not provide)
Step 1:
.
Assemble two regular casters to the right side panels and caster with brakes on the left side panel as shown figure below..
Step 2: : Assemble bottom panel to side panels with eight (8) 1/4x38 mm screws as shown figure below
5
Step 3: Assemble the back panel to the two sides panel. with four (4) 1/4x12mm screws as shown figure below.
Step 4: Assemble the cart flame to the front side of the side panel with four (4) 1/4x38mm screws . Please attention Don’t
screw them too tight in the beginning
6
Step5: Remove the head unit of grill from carton. Insert the upper portion of the grill onto the cart from
the top with four (4)1/4x12mm screws. Caution!! The firebox is heavy, and we recommend two or
more people to lift up firebox.
Step 6 : 1.Place flame tamers (3) on to the fire box as show figure below.
2.Place the cooking grids(2) on.
3. Place the warming rack on.
7
Loading...