Page 1
1
Introduction
US Patent # 7172307
US Patent # 9458970
SOLAR LAMP
Instruction Manual
Thank you for your purchase! Our solar charged accent lighting eliminates the
problems associated with most solar lighting available today. Our solar charged
lights are brighter and last all night with a typical solar charge. Unique design,
superior light output and numerous installation options confirm the
outstanding value of our product.
The company also offers unique multi-purpose rechargeable products that range
from party lights to emergency lighting products.
Page 2
2
Please read the instruction manual carefully to obtain the best results from your
purchase.
NOTE: If you are replacing an existing gas/electric post light, you must consult a
certified technician to cancel them before installation.
1. Solar Lamp Location
For optimum light duration throughout the night, it is very important to mount
your solar lamp post in a spot where it will receive the maximum amount of
direct sunlight throughout the day. The solar light must be charged in full sun for
two days in the “ON” position for the best results.
NOTE: The following steps are for reference only. Consult your local hardware store
for the best installation method for your chosen surface.
2. Assembly Instructions
(Fig. 1).
4. Reverse step 2 and re-attach fixture top.
3. Installation Instructions
NOTE: The following steps are for reference only. Consult your local hardware store
for the best installation method for your surface.
(3" Fitter Mount)
1. Attach Part (A) to the bottom of the fixture by twisting
clockwise.
2. Place the entire fixture on top of the existing 3” post and hand
tighten using the 3 set screws provided.
**WARNING DO NOT OVERTIGHTEN SCREWS**
A
(Fig. 1)
WARNING: These Light bulbs are built and designed for our products only.
They are not designed to be used in other electrical sockets. For the same reason, regular AC
and/or Low Voltage bulbs cannot be used in our products.
1. Screw lamp finial into the top of the lamp.
2. Using a screwdriver remove both screws and remove the fixture top.
3. Screw in provided A-60 bulb while gripping the base only see
Page 3
3
(Pier Mount)
1. Attach Part (B) to the bottom of the fixture by twisting clockwise.
2. Use an electric drill to make four holes in the desired surface.
Place provided anchors into holes, place the base of the lamp in
line with the holes and attach with the provided screws.
(Wall Mount)
1. Attach Part (C) to the bottom of the fixture by twisting clockwise.
2. Remove the silver back bracket by removing the 2 screw
caps on the front face of the wall mount see (Fig.2).
3. Screw the silver bracket onto the desired surface.
4.
Note: Installing the light on a wall may limit the solar panel for sun exposure. Make
sure the lamp is mounted so direct sun exposure is available.
4. Operation Instructions
1. Turn the external operation switch to Low or High
position (Fig. 3) according your preferences:
a. For softer light and longer duration.
b. For brighter light output.
2. The solar lamp will automatically operate at
dusk.
5. Replacing the Batteries
(After several years of use, the batteries may need replacing).
1. Make sure the ON/OFF switch is in the “OFF” position (0).
2. Unscrew the two screws on the upper part to detach
it from the lamp (Fig. 4).
3. Unscrew the battery compartment’s screws located on
the silver reflector and remove the compartment doors.
4. Unclip the battery connectors and remove the old
batteries. Make sure the new batteries are high quality –
Li-Ion Battery packs (3.2 Volt / 1500 mAh) with matching
connector.
5. Install the new batteries into the battery compartment.
6. Reassemble the unit by reversing the above procedure.
B
(Fig. 2)
(Fig. 3)
(Fig. 4)
C
Place lamp onto bracket and replace the 2 wall mount
screw caps.
Page 4
4
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum
performance. Do not use any type of solvent for cleaning and be careful not to put
too much pressure on the solar panels while cleaning.
Trouble Shooting
If your solar charged light does not come on at dusk despite observance of all the
instructions, please try the following steps:
1. Make sure that the solar lamp post is not being affected by any other
light source.
2. Ensure the solar lamp post is not positioned in the shade during the
day.
3. Make sure the switch on the lamp head is in either the Low or High
position.
4. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp post will vary with the time of year. It will
deliver more light when it has had a full day in the sun rather than a day in overcast
weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the
batteries much more efficiently.
WARNING: Please keep out of reach of children. Do not dispose of Li-Ion battery in
the regular trash, municipal waste stream or by fire as batteries may leak or explode.
Do not open, short circuit, or mutilate batteries as injury may occur. Preserve our
environment by recycling Li-Ion batteries or disposing of them in accordance with
local, State and federal regulations. Do not mix old and new batteries.
Loading...