Page 1
DINING CHAIR DINING CHAIR
HARDWARE :
A×9
Φ8
Flat washer
PARTS LIST
B×9
Φ8
Lock washer
G×1
C×1 E×4
M8
Allen key
H×1
Back
D×1
M8x55MM
Shorter Screw
I×2
Seat
Front Legs
1/3
F×4
M8x60MM
Medium Screw
M8x75MM
Longer Screw
Page 2
1
H
Put chair back on a clean flat surface.
Place seat pad against chair back as
shown in diagram.
C
D
A
B
D
A
B
60%
Secure center holes of the seat pad to
chair back by using SHORTER
SCREW (D) with Washer (#A,B).
DO NOT FULLY TIGHTEN.
2
G
A
B
F
A
F
First HAND tighten then tightened using
key up-to 60-80% only at this stage.
C
60%
Secure both corner holes of the
seat pad to the chair back by using
B
LONGER SCREWS (F) with
washers ( #A,B).
DO NOT FULLY TIGHTEN.
First HAND tighten All 4 screws
TOGETHER at the same time.
3
Tightened up-to 60-80% using key
only at this stage.
C
60%
E
B
A
C
A
B
E
E
B
A
C
Align front legs in the seat pad as shown
in the diagram.
Firm pressure is required to push the legs.
use parts C,E,A,B,to secure Again
Secure both corner holes of the seat pad to
the chair back by using screws
MEDIUM SCREWS (E) with washers ( #A,B).
DO NOT FULLY TIGHTEN.
First HAND tighten All 4 screws TOGETHER
at the same time.
Tightened up-to 60-80% using key only
at this stage.
2/3
Page 3
4
Put chair in the upright position and
SIT ON THE CHAIR to press downwards
on the seat pad ensuring that all 4
feet touch the ground and chair is leveled.
Proceed to tighten all screws making sure
the chair remainslevel when tightening.
Check that all screws are tight on a regular
basis to ensure chair remains level and secure.
5
6
TROUBLESHOOT
One screw is in and other screw does not go in. Or Holes
are not align.
1. Make sure to use 4 Medium screws (E) in Front Corner, 1 Shorter
screw (D) in Back Center and longer screw (F) in the Corner Back.
2. Loosen the screw and then First HAND tightened All screws
TOGETHER at the same time. then tightened to 60-80% at this
stage only using key.
3. If both above steps are correct, please use Key to secure screws.
It might be little stiff.
Chair Legs are not level or shorter legs.
If the screws are fully tightened. Loosen screws up-to 60%.
Put chair in the upright position and SIT ON THE CHAIR to press
downwards on the seat pad ensuring that all 4 feet touch the
ground and are leveled. Tightened all one by one.
Do not fully tighten the Bolts (screws) when assembling
the chair.Tighten all bolts about halfway.
Carefully put the chair on flat surface.
Please put a heavy object or seat one adult on top of
the Chair Body on top of the Chair Seat to pressure the
chair leg for leveling.
Once All legs are levelled, tighten all the bolts fully.
3/3
Also you can using adjustable
feet to keep four legs level .
Loading...