Page 1
Fig. 1
Fig. 2
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old fixture,
including the mounting hardware. Carefully unpack your new fixture
and lay out all the parts on a clear area. Take care not to lose any
small parts necessary for installation.
2. Attach the fixture body (M) to top cover (J) with cap nuts (K).
3. Thread nipple (E) into crossbar (A) and secure with lock washer (D)
and hex nut (C) until snug. Thread the other end of nipple into chain
loop (G). Take this crossbar assembly and mount to the ceiling outlet
box with screws (B). The side of the cross bar marked “GND” must
face out.
4. Use a pair of proper chain pliers to open one end link of the chain
provided and connect to the fixture loop (I). Close the link. Determine
correct number of links needed for proper hanging height. Remove
and discard excess chain.
5. Carefully lace the fixture wires through the chain. Slip lock collar (H)
followed by canopy (F) over the chain and allow them to rest on the
fixture top cover (J). Open the other end link of chain and hang the
fixture onto chain loop (G). Close the link. Carefully feed the fixture
wires through chain loop (G) and nipple (E).
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig.2.Making sure that all
wire connectors are secured. If your outlet box has a ground wire
(green or bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to the circular
strap using the green screw provided.
COMPLETING THE INSTALLATION (Fig.1)
7. Align canopy (F) to the ceiling and secure with lock collar (H) to
chain loop (G).
8. Bulb (L) information: (1 x AC LED 10W included.)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without
cutting of wire and without damage to any decorative element to which
the fixture is attached. See installation steps for more details (Fig. 3)
a. Carefully remove cap nuts (K) to separate fixture body (M) from top
cover (J) (Fig.1). Next remove aluminum plate (O) from top cover
(G) by loosening screws (K).
b. Remove wire nuts (L) hex-nuts (N) washers (M) and carefully
remove LED module (Q). Note: The LED module should be
provided by a specified supplier.
c. For better heat dissipation the LED module (Q) should be installed
with the heat transfer material (P) when re-lamping
Your installation is now complete. Return power to the junction box and
test the fixture
FIXTURE
WIRES
Black or
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(G
Fig. 3
N
M
J (Glass)
I (Module ring)
H (Module screws)
Q (LED module)
P (Graphite sheet)
O
L
K
INSTALLATION INSTRUCTIONS
WARN ING ! S HU T P OWE R O FF AT F U SE OR CIR CU IT BRE AKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Loading...