Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Mounting Strap (A)
Fixture Mounting
Screw(D)
Ball Nut (G)
Mounting Screw (B)
Green Grounding
Screw (E)
Wire Nut (C)
Lock Nut (F)
Installation Steps
Turn off the power at fuse or circuit box
1. Attach two fixture mounting screws to the mounting
strap, and then secure it with two lock nuts. Adjust
the length of the fixture mounting screws if necessary.
2. Attach the mounting strap to the outlet box using two
mounting screws.
3
. Rod Connections:
a. Thread the fixture wire from the fixture through the
lower rod, and then secure the lower rod onto fixture
using the threaded pipe.
b. Thread the fixture wire through the middle rod, and then
secure the middle rod onto the lower rod using the
threaded pipe.
c. Thread the fixture wire through the upper rod, and then secure the
upper rod onto the middle rod using the threaded pipe.
Outlet Box
House Grounding Wire
Wire Nut(C)
Fixture Mounting Screw (D)
Mounting Strap(A)
Lock Nut(F)
Mounting Screw(B)
Green Grounding Screw(E)
Fixture Canopy
Ball Nut (G)
Threaded Pipe
Upper Rod
Threaded Pipe
Middle Rod
Threaded Pipe
Lower Rod
Threaded Pipe
Fixture body
d. Thread the fixture wire through the fixture canopy, and then secure
the fixture canopy onto the upper rod using the threaded pipe.
Note: Length adjustable from 19-1/4" to 64-1/4". Use
fewer rods if shorter length is desired.
Bulb Type A Max.100W
(not included)
Socket
Glass Shade
Spacer
Socket ring
Bulb
Page 2
4. Pull out the source wires from the outlet box. Make wire
connections using wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to
the black wire from the power source.
Fig. 1
Support Brace
---Connect the ribbed-coated wire (unmarked) from the fixture to
the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with
the green grounding screw, and then connect it to the
house grounding wire with a wire nut.
Outlet Box
Canopy
Carefully put the wires back into the outlet box.
Coupling Kit
5. Attach the canopy kit to the mounting strap by inserting the fixture
mounting screws, and then secure it with two ball nuts.
6. Attach the glass shade onto the socket, secure them with spacers
and socket rings.
Noted: Make sure the opening side of the spacer facing up.
7. Install the bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
8.Angled mounting recommended for a vaulted or angled ceiling. (See Fig. 1)
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Strap (A)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Green Grounding
Screw (E)
12"L Rods
w/threaded pipe
6"L Rod
w/threaded pipe
3"L Rod
w/threaded pipe
Lock Nut (F)
Mounting Hardware
(1 SET)
Wire Nut (C)
Finial (G)
Glass Shade
A: 5
"
B: 19-1/4"~64-1/4
"
Loading...