Assembly Instructions
Caution: You must read this before you proceed
Chair
Parts List
Label Picture Description QTY
A
Left Arm
1
B
Right Arm
1
C
Back Cushion
1
Page 1 OF 10
D
Seat Base
1
E
Front Seat Board
1
F
Seat Cushion
1
G
Backrest
1
H
Wooden Leg with 1
Plastic
Gasket
4
Hardware List
Label Picture Description QTY
①
Plastic Gasket 3
Page 2 OF 10
Assembly Preparation
Before Begining
Assembly:
Page 3 OF 10
Assembly Steps
This Chair has multiple parts and may require about 30 minutes to assemble. To give you an
overview of the Chair parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the parts
and steps before assembly.
Step 1
Front Seat Board (E)
Back Cushion(C)
Seat Base(D)
Left Arm (A)
Wooden Leg(H)
Right Arm (B)
Backrest(G)
Seat Cushion (F)
Page 4 OF 10
Open the bubble pack to take out the Wooden Legs(H)and Plastic Gaskets(①).
Step 2
Carefully Install the Legs with 1 Plastic Gaskets(H) at the bottom of the Right Arm(B) and Left
Arm (A).
Insert threaded stem into the mounting position at the bottom of the Right Arm(B) and Left
Arm (A). Tighten by turning the Legs clockwise.
Take care of the shape of the Legs and ensure they in the correct postions.
Note:The use of Gaskets are OPTIONAL and are especially useful to help alleviate slight
wobbleness. Some Legs may need more than one gasket while some legs may not need any.
Bubble Pack
①
H
Page 5 OF 10
Step 3
With assistance from your adult partner, postion the Left Arm (A) and Right Arm (B) as
picture, hold up the Front Seat Board(E) and stand front the both Arms, assemble the Front
Seat Board(E) by putting the metal hook on the two raised metal support points on the front
side of both arms, do it one by one and make sure into position.
Page 6 OF 10
Step 4
With assistance from your adult partner, postion the Left Arm (A) and Right Arm (B) with
Front Seat Board(E) as picture, hold up the Backrest(G) and stand behind the both Arms.
Align the mounting brackets of Backrest(G) on the side of Left Arm(A) and Right Arm(B),Then
Slide the Backrest(G) forward by hand to make sure it locks into the position as shown in the
picture.
Page 7 OF 10
Step 5
With assistance from your adult partner,hold up the Seat Base(D) on the top of the
assembled parts,put the front side of seat Base(D) over on the rail of front seat board as
picture.
then slide the two downward hooks on each side of the Seat Base(D) into the upward hooks
slot on the Left Arm (A) and Right Arm (B),do it one back one and make sure into the
position.
Step 6
Put the Seat Cushion(F) on the Seat Base(D).
Page 8 OF 10
Step 7
Place the Back Cushion(C) on the Seat Cushion(F) and against the Backrest(G).
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Page 9 OF 10
Page 10 OF 10
Loading...