Page 1
1
Introduction
Please read the instruction manual carefully to obtain the best results from your
purchase.
US Patent # 9458970
FINIAL SOLAR LIGHT
Instruction Manual
Thank you for your purchase! This solar charged accent lighting eliminates the
problems associated with most solar lighting available today. This solar
charged lights are brighter and last all night with a typical solar charge. Unique
design, superior light output and numerous installation options confirm the
outstanding value of our product. The company also offers unique multi-purpose
rechargeable products that range from party lights to emergency lighting products.
Page 2
2
A
Fig. 1
Fig. 2
Solar Lamp Location
For optimum light duration throughout the night, it is very important to mount
your solar lamp post in a spot where it will receive the maximum amount of
direct sunlight throughout the day. The solar light must be charged in full sun for
two days for the best results.
Assembly Instructions
1. Remove Part A from Part D.
3. Place Part B onto Part D; and then slide Part A on top of Part B.
Make sure Part A is aligned with the photocell (Fig 1).
4. Flip the light upside down and secure Part D into Part A using 4 screws.
D
PHOTOCELL
A
C
B
2. Grip the base of bulb Part C; and screw into Part D.
Page 3
3
5. Unscrew the battery door and plug in the 3.2V 3,000 mAh Li-Ion battery
(Included) to the matching connector (Fig 2).
6. Re-attach the battery door securely and turn the light fixture right side up.
NOTE: The following steps are for reference only. Consult your local hardware store
for the best installation method for your surface.
Installation Instructions
sides of the light fixture.
Replacing the Batteries
(After several years of use, the batteries may need replacing)
1. Unscrew the battery compartment’s door located on the bottom of
the light fixture; and remove the compartment door (Fig 2).
2. Unclip the battery connectors and remove the old battery. Make sure
the new battery is a high quality – Li-Ion Battery pack (3.2 Volt / 3000
mAh) with matching connector.
3. Install the new battery into the battery compartment.
4. Replace the compartment door by reversing Step 1.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum
performance. Do not use any type of solvent for cleaning and be careful not to put
too much pressure on the solar panels while cleaning.
Trouble Shooting
If your solar charged light does not come on at dusk despite observance of all the
instructions, please try the following steps:
1. Make sure that the solar lamp post is not being affected by any other
light source.
2. Ensure the solar lamp post is not positioned in the shade during the
day.
3. Check that the batteries are installed correctly.
1. Place the completely assembled on your desired surface.
2. Using a drill, install the two remaining screws in the open holes on the
Page 4
4
NOTE: The performance of the solar lamp post will vary with the time of year. It will
last longer when it has had a full day in the sun rather than a day in overcast
weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the
batteries much more efficiently.
WARNING: Our Light bulbs are built and designed for our products only. They are not
designed to be used in other electrical sockets. For the same reason, regular AC
and/or Low Voltage bulbs cannot be used in our products.
WARNING: Please keep out of reach of children. Do not dispose of Li-Ion battery in
the regular trash, municipal waste stream or by fire as batteries may leak or explode.
Do not open, short circuit, or mutilate batteries as injury may occur. Preserve our
environment by recycling Li-Ion batteries or disposing of them in accordance with
local, State and federal regulations. Do not mix old and new batteries.
Loading...