Charlton Home W000957368 Installation Instructions

PREPARING FOR INSTALLATION (Fig. 1)

1. Shut off power at the circuit breaker and remove the
old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.

3. Thread the two studs (B) into the pre-drilled holes in
the circular strap (C) spaced the same distance
apart as the holes in the back plate (H), and secure
with hex nuts (E). The length of studs (B) into
circular strap (C) may be adjusted if necessary.

4. Attach circular strap (C) using outlet box screws (F)
to the outlet box (A), (Fig 1).

CONNECTION THE WIRES (Fig. 2)

5. Connect the electrical wires as shown in Fig.2.
Making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the circular strap using the green screw (D)
provided.

FINISHING THE INSTALLATION (Fig.1)

6. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.

7. Align back plate (H) onto studs (B) and secure with
cap nuts (G). (Fig 1)

8. At this point, unscrew finial (J) and hex nut (K),

remove cage (I) to install 2*60W/E12/B bulb (not
included) in accordance with the fixture
specification—DO NOT EXCEED THE MAXIMUM

WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)

9. Replace cage (I), secure with the nut (K) and finial
(J).

Your installation is now complete. Return power to the
outlet box and test the fixture.

Fig. 1

“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”

ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.

D

E

F

A

C

B

States Federal and/or State Law,
including Patent and/or Copyright laws.

BARE COPPER(GROUND)

Fig.2

FIXTURE
WIRES
WHITE

BLACK

(HOT)

WIRES

HOUSE

GREEN OR

WHITE
(NEUTRAL)

WIRES

HOUSE

(GROUND)

COPPER

BARE

FIXTURE
WIRES

BLACK

WIRES

FIXTURE

GREEN OR

HOUSE
WIRES

INSTALLATION INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

WARNING ! SHUT P O WER O F F AT F U SE OR C I RCUI T BREAK E R.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

U.S. Patents: D457,681; D461,591;
D463,062
This product is protected by United