Page 1
Caution : You must read this before you proceed
Club Chair
Page 1 OF 6
Page 2
Label Picture Description QTY
A Backrest 1
B Seat 1
C Front Leg 2
D Back Leg 2
Label Picture Description QTY
① Gasket 7
② Bolt (M8*120 MM) 2
③ Washer 2
④ Allen Key 1
Before
Beginning
Assembly:
Page 2 OF 6
Page 3
Step 1
Position the Seat(B) on its back on a clean, non-marring surface as above.
Carefully unzip the pouch at the bottom of the Seat(B) and remove the Front Legs(C), Back Legs(D) and
Hardware.
Close the pouch.
This Club Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview
of the Club Chair, the above picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and steps before assembly.
Overview
FRONT FACING
Backrest(A)
Front Leg(C)
Seat(B)
Back Leg(D)
Seat(B)
Page 3 OF 6
Page 4
Install the first Front Leg(C) into the base of the Seat(B) by placing one Gasket(①) onto the threaded stem.
Insert the threaded stem of the Front Leg(C) into one of the front mounting positions of the Seat(B), then
tighten by turning the Leg clockwise until it is completely secure.
Repeat this process with the remaining three Legs.
Note: The use of the Gaskets are OPTIONAL and are especially useful to help alleviate slight
wobbles. Some Legs may need more than one whilst some Legs may not need any.
With assistance from an adult partner, lift the Backrest(A) up.
Align the Rails on the Backrest(A) and Seat(B).
Note: Make sure the Rails on the Backrest(A) locks into the Rails on the Seat(B).
Step 2
Step 3
Use Gaskets(①)
to achieve stablity
Rail on Seat(B)
Rail on
Backrest(A)
Front Leg(C)
Front Leg(C)
Back Leg(D)
Seat(B)
Gasket(①)
Backrest(A)
Seat(B)
Back Leg(D)
Front Leg(C)
Page 4 OF 6
Page 5
Step 5
Your Club Chair is ready for use.
This Club Chair can only be used on a flat, level surface.
Step 4
Put the Club Chair facedown as pictured above.
Lock Seat(B) to Backrest(A) using Bolt(②) and Washer(③) with Allen Key(④).
Tighten the Bolt fully.
④
②
③
Seat(B)
Backrest(A)
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...