Page 1
Platform Bed
Congratulations on the purchase of your Platform Bed. This bed has been crafted to the highest standards of quality
and safety and will give you many years of enjoyment and practical use.
On this insert you will find a list of the hardware and platform bed parts included as well as detailed assembly
instructions. Assembly is quite simple and requires only a flat head screwdriver and a Phillips head screwdriver. The use
of a power drill with Phillips head attachment is helpful but not necessary. Assembly will be most easily accomplished
if you take the time to carefully sort the hardware and familiarize yourself with the function of each piece.
If you need assistance with assembly, part replacement or any other matter, please contact the toll-free Customer
Service Team. You may also email your request or comments and a customer service representative will respond.
Thank you and Enjoy
HARDWARE LIST
70mm bolts
Used to connect drop supports
to center supports
FULL (1) QUEEN (1) KING (2)
B F E
2 Side rails
Connect end boards
30mm slat screws
Used to secure slats to rails
FULL (36) QUEEN (39) KING (52)
Hex key
Used to tighten bolt hardware
BED PARTS
1 Slat bundle
Rest on side rails and supports
mattress (strap side down)
FULL / QUEEN
A C
Barrel nuts
Used to secure bolts
FULL (1) QUEEN (1) KING (2)
D
15mm wood screws
Used to secure center support
FULL (4) QUEEN (4) KING (8)
Drop supports
Used to attach center support
FULL (1) QUEEN (1) KING (2)
1 Headboard
A C D
Headboard
1
1 Footboard
KING
1 Footboard
1 Center support
Used to attach
drop support
2 Center supports
Used to attach
drop support
Page 2
1
2
B
A
A
B
Arrange the bed pieces as
shown, makeing sure the slat
rails ledges are facing the
inside of the bed. Slide the
notches in side rail B into the
holes in headboard A.
B
C
B
C
Tap the top of the rail ends
B gently with a rubber
mallet to make sure the
connections are secure.
FULL & QUEEN KING
Slide the notches in
side rail B into the
holes in footboard C.
Insert the center support beam B into the
3
brackets in the headboard and footboard.
Drive two wood screws through the holse in
each side of the headboard bracket and
footboard with a Phillips Head screwdriver.
Place the barrel nut into
the hole in the side of the
drop support E.
D
Then insert a 90mm
bolt through the
center support D
into the barrel nut.
E
Tighten with the
Hex key provided.
Spread the slat bundle (strap side down) evenly
4
across the slat rails. Use the wood screws to
secure all slats to the slat rails with a Phillips
Head screwdriver. A power screw driver
comes in handy here.
F
Loading...