Caution :You must read this before you proceed
Club Chair
Page 1 OF 5
Label Picture Description QTY
A Chair 1
B Front Leg 2
C Hind Leg 2
Label Picture Description QTY
①
Gasket 7
Before
Beginnin
g
Assembl
y:
Page 2 OF 5
Overview
This Club Chair has multiple parts and may require up to 30 minutes to
assemble.
To give you an overview of the Club Chair parts, the above picture is to
help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.
Step 1
FRONT FACING
Front Leg(B)
Hind Leg(C)
Chair(A)
Chair(A)
Page 3 OF 5
Install the first Front Leg(B) into the bottom of the Chair(A) by placing one
Gasket(①) onto the threaded stem.
Insert the threaded stem of the Front Leg(B) into the front mounting position
of the Chair(A) then tighten by turning the leg clockwise until the leg is
completely secure.
Repeat this process with the remaining three Legs.
Note: The use of the Gaskets are OPTIONAL and are especially useful
to help alleviate slight wobbles. Some Legs may need more than one
whilst some Legs may not need any.
With assistance from your adult partners, position the Chair(A) on it's back
on a clean, non-marring surface, as shown.
Unzip the pouch and remove the four Legs and Hardware.
Close the pouch before assembling.
Step 3
Make sure all parts are connected and locked into position.
Your Club Chair is ready for use.
This Club Chair can only be used on a flat, level surface.
Step 2
Use Gasket(①) to
achieve stability
Front Leg(B)
Hind Leg(C)
Front Leg(B)
Hind Leg(C)
Page 4 OF 5
Page 5 OF 5
Loading...