Page 1
Label Picture Description QTY
A
Table Top 1
B
Table Leg with pre-
attached Levellers
4
Caution : You must read this before you proceed
End Table
Picture
CAUTION : This table is NOT a TOY.
Keep your child / children at bay during the assembly process.
Noble house Home Furnishings LLC
Page 1 OF 6
Page 2
Label Picture Description QTY
①
Bolt(M8*30mm) 5
②
Washer(8mm) 5
③
Spring Washer(8mm) 5
④
Nut(8mm) 5
⑥
Spanner 1
⑦
Screwdriver 1
⑧
Rubber Cap 5
Before
Beginning
Assembly:
Noble house Home Furnishings LLC
Page 2 OF 6
Page 3
Step 1
Step 2
This Table has multiple parts and may require up to some 30 minutes to
assemble.
To give you an overview of the Table parts, the above picture is to help
you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.
Unpack and place all parts on a clean, soft surface.
Lay the Table Top(A), facedown, onto a flat, soft, clean surface and lock
the mounting positions with bolts(①) by using Screwdriver(⑥).
Repeat the same process for the mounting positions of the Table Top.
Need tighten the bolts.
Overview
Table Top(A)
FRONT FACING
Table Leg(B)
Noble house Home Furnishings LLC
Page 3 OF 6
Page 4
Step 3
Step 4
Attach the Table Leg with pre-attached Levellers(B) to the Table Top(A)
using Washers(②), Spring Washers(③), and nuts(④) with spanner(⑦).
DO NOT OVERTIGHTEN.
Repeat step 3, attaching the remaining 3 table legs to the Table top(A).
At this stage, only loosely tighten the Bolts.
A
B
B
A
Noble house Home Furnishings LLC
Page 4 OF 6
Page 5
Step 5
Step 6
Adjust the Legs pre-installed Levellers until the Table is level with the
ground.
Add Rubber Caps(⑧) on all bolt ends to protect skin or clothing from
getting snagged.
Caution: This TABLE can only be used on a flat, level surface.
Stand the table right side up.
Tighten the Levellers.
Inspect it and make sure all parts are adequately connected.
Now, fully and securely, tighten all nuts, at all joints.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
If there is still wobbles, loosen the bolts and execute this same
process.
If the Table is not stable it could lead to damage to the product.
Adjust height
for balance
Adjust low
for balance
Noble house Home Furnishings LLC
Page 5 OF 6
Page 6
Noble house Home Furnishings LLC
Page 6 OF 6
Loading...