ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
Outlet Box
Wire Nut
House Grounding Wire
Mounting Strap
Green Grounding Screw
Mounting Screw
Key Hole Slot
Screw
Fixture Grounding Wire
Socket
Pan
Coupling
Washer
Screw
Fig.1
Hex Nut
Nipple
Glass Shade
Hex Nut
Finial
1. Attach two screws to the mounting strap, screw them in a little.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make
wire connections using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
4. Attach the pan to the mounting strap by inserting two screws, and rotate the pan until it
locks in place. Then secure the screws tightly with a screwdriver.
5. Install bulbs (not included). See relamping label at socket area or packaging for
maximum allowed wattage.
6. Screw the nipple into the coupling, then secure it with a washer and hex nut.
7. Attach the glass shade to the pan by inserting the nipple, then secure it with a hex nut
and finial.
8. Turn on the power at the main fuse or circuit breaker box.
Loading...