Page 1
Description
ASSEMBLY INSTRUCTIONS
: MISSION END TABLE
- 1 -
Printed in Vietnam
Page 2
PART
LIST
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A
C
Top 1
Side frame
(L-R)
2
Bottom shelf 1
B
- 2 -
Printed in Vietnam
Page 3
HARDWARE LIST
STEP 1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Long bolt
(M6x35mm)
8
2
Spring washer
(∅6.5x13mm)
8
1
3
Flat washer
(∅6.5x19mm)
8
4
Allen key
(4X80mm)
Attach side frames (C) to top (A) with bolts (1), and washers (2) and (3) as shown below. Tighten with
Allen key (4).
- 3 -
Printed in Vietnam
Page 4
STEP 2
Attach bottom self (B) to side frames (C) with bolts (1), and washers (2) and (3) as shown below.
Tighten with Allen key (4).
Printed in Vietnam
- 4 -
Loading...