Assembly Instruction
ACCENT CHAIR
NO.
DRAWING
QTY
DESCRIPTION
Ａ
１PC
CHAIR
B
2 PCS
FRONT LEG L& R
C
2 PCS
REAR LEG L & R
D
4PCS
BOLT (M8×80mm)
（FRONT LEG）
E
8PCS
WASHER
F
1PC
ALLEN KEY
G
4PCS
BOLT (M8×65mm)
(REAR LEG)
NOTE: Do not use power tools for assembly. Power tools increase the risk of over tightening which
lead to splitting or cracking the wood.
COMPONENT LIST (ACCENT CHAIR)
drawing, please take out for assembly.
Legs and Hardware set are stored at the bottom seat inside the dust cover as shown in
STEP#1
Front Leg Assembly:
Align and insert front legs to the front seat frame pre-drilled holes, make sure both pre-drilled
holes are in line, insert bolts D and washers then tighten with Allen Key.
Rear Leg Assembly:
Align and insert rear legs to the rear seat frame pre-drilled holes, rear legs curves must facing
outward, make sure both pre-drilled holes are in line, insert bolts G and washers then tighten with
Allen Key.
STEP#2.
Check all the bolts are tighten securely in position, put the dust cover back to the position. Upright
the chair and make sure the chair is stable.
Chair Assembly is completed.
Avoid exposing furniture directly to sunlight or heating and air conditioning outlets. Sunlight and/or exposure to
For items use on wooden floor, hard surfaces or carpets, it is
Care Instruction for Fabric Furniture.
In order to maintain the original appearance of your fabric furniture, please follow below simple care procedures:
heating and air conditioning outlets will fade/damage fabric.
Vacuum or wipe with a soft brush to remove dust.
Clean fabric furniture with professional cleanser.
recommended to Install protective pads under all legs and supports to
avoid/prevent from damages/scratches and discoloration.
Loading...