Charbroil 463731703 Owner's Manual
1
Qty: 6
Items to Assemble:
6 Carriage Bolts
6 Wing Nuts
Qty: 6
Place Bottom Shelf and Legs as shown.
After assembling tighten all Wing Nuts.
(Use both Upper and Lower Holes)
2 Carriage Bolts and Wing Nuts
Right Side:
2
Items to Assemble:
2 Wheel Assemblies
2 Leg Extenders
2 Hitch Pins
Hitch Pin - Qty: 2
Attach hitch pins to axle rod on wheel assembly
after pushing through leg and shelf
3
Items to Assemble:
1 Panel
2 Push Pins
1 Wire Shelf
A.BPlace tabs into slots on bottom shelf
. Place wire shelf in 3rd hole from top
B
A
Left Side: Use Upper Hole ONLY)(
to attach 1 Carriage Bolt and Wing Nut
4
Items to Assemble:
1 Grill Bottom with Control Panel
1 Heat Shield
2 Carriage Bolts
2 Wing Nuts
Qty: 2
Qty: 2
5
Qty: 4
Items to Assemble:
1 Right Shelf
4 Crown Nuts
4 Carriage Bolts
Qty: 4
6
1st:
Qty: 2
Items to Assemble:
1 Sideburner Body 1 Sideburner Frame
1 Sideburner 1 Knob
1 Grate 1 Carriage Bolt
2 Wing Nuts 1 Crown Screw
2 End Caps
ASSEMBLER NOTE: Assemble front panel first by placing tabs into slots on bottom shelf
before inserting wire shelf
Qty: 2
Qty: 1
Place Sideburner into hole.
Insert Valve into Sideburner Tube.
Fasten Wing Nut
Correctly assembled Sideburner Tube in Valve
4th:
3rd:
Sideburner
electrode
Qty: 1
2nd:
5th:
Locate the long
sideburner ignitor wire
(attached to ignitor
behind control panel).
Atttach to electrode on
bottom of sideburner
7
Items to Assemble:
1 Vaporiser Bar
1 Grate
Grate Rests
Push Vaporiser Bar down onto rest in
Grill Bottom
8
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Logo Plate
1 Handle
2 Wing Nuts
Qty: 2
Qty: 2
Qty: 2
Hinge Pin
and Hitch Pin
Item to Assemble:
9
1. Insert pivot wires int lid (A).
2. Flex leg wires to insert into holes in grill bottom (B).
1 Warming Rack
(A) Pivot Wire
(B) Flex to insert
Items to Assemble:
1 Grease Clip
10
1 Tank Wire Support Bracket
1 LPD Gas Tank
•Hang grease clip from center of grill bottom.
•Use an empty soup can (not included) to hang
from grease clip.
!
CAUTION
• Failure to install can in clip will cause hot
grease to drip from bottom of grill with
risk of fire or property damage.
LP tank is shipped empty. Fill and leak check before
attaching to grill and regulator.
See Use and Care to perform the “Burner Flame Check”
and important safety instructions before using
!
CAUTION
Tank collar opening must face to front of cart once tank is
attached.
Failure to install tank correctly may allow gas hose to be
damaged in operation, resulting in the risk of fire.
11
Correct position of LP tank
and tank wire support
bracket after grill assembly
Rear View
of Grill
463731703
Loading...