Charbroil 463363006 Installation Instruction
Items to Assemble
1 Electrode w/Wing Nut or Nut
7
A Inside bottom casting insert electrode and
finger tighten with wing nut or nut.
View of electrode attached
and aligned with a porthole
in the burner.
Finger Tighten
A
Front
Items to Assemble
1 Control Panel
8
4 Screws
A Hold control panel close to bottom
casting. Attach ignitor wire to electrode.
B Insert regulator into opening in front
panel.
C Position valves into burner tubes (see
burner-valve view). Rotate control panel
up and rest flange over rail.
D Attach control panel to legs with screws
Qty: 4
Burner Tubes
Items to Assemble
9
A
D
A
C
Correctly assembled burner tube and valve.
2 Shelves
A Shows a close up of the rectangle hole that holds the shelves in place.
Press side shelf firmly onto the rails until it is fully secured to the rails.
B Shows shelf properly attached.
B
Tab fully secured
C
B
D
D
Rectangular holes
A
A
10
Items to Assemble
1 Top Casting Assembly
2 Shoulder Bolts
3 Control Knobs
1 Handle
2 Wing Nuts
A
A Attach lid with shoulder bolts.
B Attach handle with wing nuts.
C Place knobs on valve stems.
B
C
_
Qty. 2
Qty. 2
11
Follow these instructions to install Logo Plate, Bezel and Temperature Gauge into Grill Lid (if necessary)
Items to Assemble
1 Logo Plate
1 Bezel
1 Temperature Gauge with Wing Nut
Grill Lid
A
Logo Plate
A Insert logo plate into grill lid.
B Center bezel over large hole on grill lid.
C Insert temperature gauge into hole on bezel and grill lid. Fasten with wing nut.
B
Items to Assemble:
12
C
3 Vaporizer Tents
2 Cooking Grids
1 Warming Rack
C
A Note correct position of vaporizer tents directly over burners.
B Place cooking grids as shown.
C Place warming rack in slots on bottom casting.
B
A
Warming
rack slots
Items to Assemble:
13
13
A LP tank is sold separately. Fill and leak check before attaching to
B Place LP tank into hole in bottom shelf. Finger tighten tank
1 LP Tank
grill and regulator.
thumbscrew to hold LP tank securely in place.
Back of cart
(Purchased)
B
BACK
See the Use & Care manual to correctly install the LP Tank,
Leak Test and do the Burner Flame Check.
!
CAUTION
Tank collar opening must face to front of cart
once tank is attached.
Failure to install tank correctly may allow
gas hose to be damaged in operation, resulting
in the risk of fire.
Items to Assemble
14
A Slide grease tray into brackets on bottom casting.
B Slide grease pan into brackets on grease tray.
1 Grease Tray
1 Grease Pan
B
Back of cart
CAUTION
Failure to install the grease tray will cause hot
grease to drip from bottom of grill with risk of
fire or property damage.
A
You may have hardware left over after completing assembly
of your grill. This is normal as in some cases we have
included extra hardware to ensure you have enough.
463363006
Loading...