1
1
Qty: 6
Items to Assemble:
2 Leg Assemblies
1 Bottom Shelf
6 Carriage Bolts
6 Wing Nuts
Left Side:
Place 1 Carriage Bolt
and Wing Nut in upper hole only
Qty: 6
Place bottom shelf and legs as shown.
After assembling tighten all wing nuts.
Right Side:
Attach 2 Carriage Bolts and Wing Nuts in
front and back.
Items to Assemble:
2 Wheel Assemblies
2
2 Hitch Pins
2 Leg Extenders
Attach wheels with hitch pins
Qty: 2
Item to Assemble:
1 Panel
3
2 Push Pins
Assemble front panel by placing
tabs into slots on bottom shelf.
Attach with push pins.
Qty: 2
4
Items to Assemble:
1 Grill Bottom
1 Heat Shield
4 Carriage Bolts
4 Wing Nuts
2 Control Knobs
Qty.4
Qty. 4
Items to Assemble:
2 Shelves
5
8 Wing Screws
Qty: 8
6
Items to Assemble:
1 V-Bar
Push v-bar down onto
rest in grill bottom
7
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Handle
2 Wing Nuts
1 Logo Plate
Qty: 2
Qty:2
Qty: 2
Hinge Pin
and Hitch Pin
Items to Assemble:
8
ABInsert pivot wire of warming
1 Warming Rack
1 Cooking Grate, Small
1 Cooking Grate, Large
rack into lid. Flex leg
wires to insert into grill
bottom.
Place cooking grates
into grill bottom.
Leg wires on warming rack
must run underneath surface.
Items to Assemble:
1 Grease Clip
9
1 Tank Wire Support Bracket
9
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang
from grease clip.
LP tank is sold separately. Use only with an
(over-fill protection device) OPD equipped LP tank.
Fill and leak check before attaching to grill and regulator.
!
CAUTION
A
B
• Failure to install can in clip will cause hot grease
to drip from bottom of grill with risk of fire or
property damage.
• Tank collar opening must face to front of cart
once tank is attached.
• Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
See Use & Care Manual for “Match Lighting Instructions” and to
perform the Burner Flame Check” and important safety
instructions before using.
Back of Grill
Grease Clip
462835205_Eng