1
Qty: 6
Items to Assemble:
6 Carriage Bolts
6 Wing Nuts
Qty: 6
Place Bottom Shelf and Legs as shown.
After assembling tighten all Wing Nuts.
(Use both Upper and Lower Holes)
2 Carriage Bolts and Wing Nuts
Right Side:
2
Items to Assemble:
2 Wheel Assemblies
2 Leg Extenders
2 Hitch Pins
Hitch Pin - Qty: 2
Attach hitch pins to axle rod on wheel assembly
after pushing through leg and shelf
3
Items to Assemble:
1 Panel
2 Push Pins
1 Wire Shelf
A.BPlace tabs into slots on bottom shelf
. Place wire shelf in 3rd hole from top
B
A
Left Side: Use Upper Hole ONLY)(
to attach 1 Carriage Bolt and Wing Nut
Items to Assemble:
4
1 Grill Bottom with Control Panel
1 Heat Shield
4 Carriage Bolts
4 Wing Nuts
Qty:4
Qty: 4
5
Items to Assemble:
2 Shelves
8 Wing Nut Screws
1 Condiment Basket
Wing Screw -Qty: 8
6
Qty: 2
ASSEMBLER NOTE: Assemble front panel first by placing tabs into slots on bottom shelf
before inserting wire shelf
Items to Assemble:
1 Vaporizer Bar
7
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Handle
2 Wing Nuts
1 Logo Plate
Qty: 2
Qty: 2
Qty:2
Hinge Pin
and Hitch Pin
Note: Grill lid
style may vary.
Items to Assemble:
1 Warming Rack
1 Cooking Grate
8
8
ABInsert pivot wire of Warming
Rack into Lid. Flex leg
wires to insert into Grill
bottom.
Place cooking grate
into grill bottom.
Leg wires on Warming Rack
must run underneath surface.
Items to Assemble:
9
A
B
1 Grease Clip
1 Tank Wire Support Bracket
1 OPD Gas Tank
•Hang grease clip from center of grill bottom.
•Use an empty soup can (not included) to hang
from grease clip.
!
CAUTION
• Failure to install can in clip will cause hot
grease to drip from bottom of grill with
risk of fire or property damage.
LP TANK SOLD SEPARATELY.
attaching to grill and regulator.
See Use and Care to perform the “Burner Flame Check”
and important safety instructions before using
!
CAUTION
Tank collar opening must face to front of cart once tank is
attached.
Failure to install tank correctly may allow gas hose to be
damaged in operation, resulting in the risk of fire.
Fill and leak check before
Rear View
of Grill
USE ONLY WITH AN (OVER-FILL PROTECTION DEVICE) LP TANKOPD
10
Correct position of LP tank
and tank wire support
bracket after grill assembly
462835203