1st: Unfold legs. Do not stand cart up until front panel is attached. The front panel stabilizes
1
1
1
1
the cart.
Items to Assemble:
2 Wheels
1 Tank Support
2 Axle Bolts
2 Hitch Pins
2 Hub Caps
1 Tank Retainer
1 1-1/4” Carriage Bolt
1 Wing Nut, Metal
3 Control Knobs
Qty: 1
Qty: 2
Qty: 1
Qty: 2
Bolt1-1/4” Carriage
Tank Retainer
Tank Support
Hub on wheel faces into leg.
Attach in bottom hole on leg
with axle bolt and hitch pin.
2
2
Qty: 4
Items to Assemble:
1 Upper Panel
4 2” Carriage Bolts
4 Wing Nuts
Qty: 4
Slide Upper Panel
under UFC
Place bolts into Upper Panel and Legs.
DO NOT ATTACH WING NUTS until
Storage Shelf is attached
Items to Assemble:
1 Storage Shelf
3
3
2 2” Carriage Bolts
2 Wing Nuts
Qty: 2
Qty: 2
On Left Legs:
Place Storage Shelf onto bolts
holding Upper Panel.
Attach bolts on left side, secure
with plastic Wing Nuts.
Storage Shelf
4
4
Items to Assemble:
1 Lower Panel
2 2” Carriage Bolts
3 Wing Nuts
Qty: 3
Qty: 3
5
5
Items to Assemble:
1 Left Shelf
2 3/4” Carriage Bolts
2 Wing Nuts
2 Wing Screws
Repeat for Right Side
1 Right Shelf
2 3/4” Carriage Bolts
2 Wing Nuts
2 Wing Screws
Qty:4
Qty: 4
Qty: 4
Make sure all
tabs are inside slots
before fastening
four
View looking down
Insert 3/4” Carriage Bolts into bracket on Legs
6
6
Item to Assemble:
1 Condiment Wire
1 Condiment Tray
B
A
7
7
Items to Assemble
3 Burner Frames
3 Burner Tents
2 Grates
1 Griddle
Griddle
Grates
Burner Tent
Burner Frame
8
8
Items to Assemble:
1 Grill Lid
2 Hinge Pin
2 Hitch Pin
Qty: 2
Qty: 2
Hinge Pin
and Hitch Pin
Note: Grill lid style may vary.
9
9
9
9
Items to Assemble
1 Chef’s Delite
2 Swing Grid Bolts
2 Wing Nuts, Metal
Note: Grill lid style may vary.
Metal
Qty: 2
Qty: 2
Items to Assemble:
10
10
Loosen wing nut on tank retainer. Center base of LP tank
A
in notches on the tank support. Lower tank holder onto tank
and tighten the wing nut.
B
Place “AAA” battery into module, secure with button.
Button
1 LP Tank
1 AAA Battery
B
+
–
Battery
A
LP tank is shipped empty. Fill and leak check before attaching
to grill and regulator.
See Use & Care to perform the “Burner Flame Check” and
important safety instructions before using.
!
CAUTION
• Tank collar opening must face to front of cart
once tank is attached.
• Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
Items to assemble:
11
11
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang from grease clip.
1 Chain with Coupling
1 Match-Holder
1 Grease Clip
Back of Grill
Grease Clip
!
CAUTION
• Failure to install can in clip will cause hot
grease to drip from bottom of grill with
risk of fire or property damage.
See Use & Care Manual for “Match Lighting Instructions”
Place end of chain through hole, reattach coupling to end of chain.
Thread eyelet on other end of chain into loop of match holder.
Remove coupling from chain
Eyelet End
Eyelet End
Match-Holder
Match-Holder
461835603