Charbroil 461834603 Owner's Manual
1st: Unfold legs. Do not stand cart up until front panel is attached. The front panel stabilizes
1
1
the cart.
Items to Assemble:
2 Wheels
1 Tank Support
2 Axle Bolts
2 Hitch Pins
2 Hub Caps
Qty: 2
Rotary Knob may be attached
1-1/4” Carriage Bolt
2
Items to Assemble:
1 Upper Panel
4 2” Carriage Bolts
4 Wing Nuts
1 Lower Panel
3 2” Carriage Bolts
3 Wing Nuts
Lower Panel inserts into Upper Panel
Slide Upper Panel
under UFC
Stand Cart Upright
3
Items to Assemble:
1 Left Shelf
2 3/4” Carriage Bolts
2 Wing Nuts
2 Wing Screws
View looking down
Insert 3/4” Carriage Bolts into bracket on Legs
1 Tank Retainer
1 1-1/4” Carriage Bolt
1 Wing Nut
2 Control Knobs
1 Rotary Ignitor
Qty: 1
4
Items to Assemble:
1 Sideburner Toolholder
1 Sideburner
2 3/4” Carriage Bolts
4 Wing Screws
Qty: 1
Qty: 2
Underside of shelf and toolholder
Wheel attaches
in BOTTOM HOLE
on legs
Tank Support
Tabs on toolholder
lock into sideburner shelf
Hub on wheel faces into leg.
Attach in bottom hole on leg
with axle bolt and hitch pin.
View looking down on 3/4” Carriage Bolts
Tank Retainer
5
Qty: 7
Item to Assemble:
1 Condiment Wire
1 Condiment Tray
Qty: 7
Qty:2
Qty:2
1st Remove styrofoam pad
Items to Assemble:
6
1 Shield
2 Tent Frames
2 Burner Tents
1 Grate
1 Griddle
Qty:2
Griddle
Make sure all
tabs are inside slots
before fastening
four
Grates
7
Qty:4
Items to Assemble:
1 Grill Lid
2 Hitch Pins
2 Hinge Pins
1 Logo Plate with clips
1 Handle
2 Wing Nuts, Metal
Qty:2
Qty:2
Hinge Pin
and Hitch Pin
8
A
Item to Assemble:
1 Warming Rack
B
Burner Tent
Tent Frame
Shield
Items to Assemble:
1 Sideburner Grate
9
1 Sideburner Knob
1 Sideburner Wire
9
1 LP Tank
Insert Sideburner Tube into Valve and snap valve cup
A
into bottom of shelf. (See inset for proper engagement).
Place Sideburner Knob.
LP tank is shipped empty. Fill and leak check before
attaching to grill and regulator.
See Use & Care to perform the “Burner Flame Check”
and important safety instructions before using.
Attach long wire from beneath console
B
to electrode beneath Sideburner.
!
CAUTION
• Tank collar opening must face to front of cart
once tank is attached.
• Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
C
Loosen wing nut on tank retainer. Center base of LP tank
in notches on the tank support. Lower tank holder onto tank
and tighten the wing nut.
Qty: 2
Qty: 2
Qty: 2
Items to assemble:
10
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang from grease clip.
1 Chain with Coupling
1 Match-Holder
1 Grease Clip
Back of Grill
!
CAUTION
• Failure to install can in clip will cause hot
grease to drip from bottom of grill with
risk of fire or property damage.
See Use & Care Manual for “Match Lighting Instructions”
Place end of chain through hole, reattach coupling to end of chain.
Thread eyelet on other end of chain into loop of match holder.
B
C
A
IMPORTANT
Proper
tube-to-valve
engagement
Grease Clip
Remove coupling from chain
Eyelet End
Eyelet End
Match-Holder
Match-Holder
461834603
Loading...