Charbroil 4618246 Owner's Manual
1
NOTE: To prevent scratching, lay grill on packing material to assemble.
Remove end of rating label on back of upper panel
and apply to your warranty card in box #5. If label
cannot be removed,write the numbers on your
warranty card.
0000000000
0000000
This label contains the model and serial number for your grill. You should write this
information on page 2 of the LP Gas Grill Use and Care in the “Warranty Information” box.
Items to Assemble:
1 Lower Panel
4
Lower Panel inserts into Upper Panel
3 2” Carriage Bolts
3 Wing Nuts, Plastic
Lower Panel
Plastic
Qty 3
Qty 3
8
Items to Assemble:
1 Logo Plate with clips
1 Heat Indicator Assy.
1 Handle
3 Wing Nuts
Qty: 3
Do not overtighten
wing nut or bend bracket
2
Qty: 2
Qty: 2
Do not stand cart up until front panel is attached. The front panel stabilizes
1st:
the cart.
Items to Assemble:
2 Wheels
1 Tank Bracket
2 Axle Bolts
2 Hitch Pins
1 Tank Retainer
-
1 1-1/4” Carriage Bolt
1 Wing Nut, Metal
3 Control Knobs
Qty: 1
Metal
Qty:
Wheel attaches
in BOTTOM HOLE
on legs
1
Wing Nut, Metal
Tank Retainer
Tank Bracket
Hub on wheel faces into leg.
Attach in bottom hole on leg
with axle bolt and hitch pin.
Stand Cart Upright
5
Bolt1-1/4” Carriage
Qty:4
Items to Assemble:
1 Left Shelf
2 3/4” Carriage Bolts
2 Wing Nuts, Metal
2 Wing Screws, “AB” point
Repeat for Right Side
1 Right Shelf
2 3/4” Carriage Bolt
2 Wing Nuts, Metal
2 Wing Screws, “AB” point
Metal
Qty:
4
Qty: 4
End has
sharp point
“AB”
Make sure all
inside slots
four tabs are
before fastening
View looking down
Items to Assemble:
1 Warming Rack
9
Insert 3/4” Carriage Bolts into bracket on Legs
Warming
Rack
Items to Assemble:
1 Grease Clip
10
3
Items to Assemble
1 Upper Panel
4 2” Carriage Bolts
4 Wing Nuts, Plastic
1 Storage Shelf
2 2” Carriage Bolts
2 Wing Nuts, Plastic
Qty 6
Plastic
Qty 6
1ST
Place bolts into Upper Panel and Legs.
DO NOT ATTACH WING NUTS
until Storage Shelf is attached.
Upper Panel
6
7
1st: Remove styrofoam pad
Items to Assemble
3 Burner Frames
3 Burner Tents
2 Grates
1 Griddle
Griddle
Items to Assemble:
1 Grill Lid
2 Hinge Pin
2 Hitch Pin
4th: Grates
3rd: Burner Tent
2nd:Burner Frame
Hang grease clip from center of grill bottom.
Hang soup can (not included) from grease clip
!
CAUTION
• Failure to install can in clip will cause hot
grease to drip from bottom of grill with
risk of fire or property damage.
Items to Assemble:
1 Chain with Coupling
11
Remove coupling from chain
Place end of chain through hole, reattach coupling to end of chain.
Thread eyelet on other end of chain into loop of match holder.
1 Match-Holder
Center of
grill bottom
Grease clip
Storage Shelf
2ND
Place Storage Shelf onto bolts
holding Upper Panel.
Attach bolts on left side, secure
with plastic Wing Nuts.
Left Side
Remove coupling from chain
Qty: 2
Back of Grill
Eyelet End
Qty: 2
Match-Holder
Hinge Pin
and Hitch Pin
See Use & Care Manual for
“Match Lighting Instructions”
4618246
Loading...