Charbroil 10501573 Owner's Manual

Outdoor Firebowl

Model 10501573

For Outdoor Use Only

CAUTION

Some parts may contain sharp edges - especially as
noted in manual. Wear protective gloves if necessary.

CAUTION

Read and follow all safety statements, warnings,
assembly instructions and care & use directions
before attempting to assemble.

WARNING

All surfaces can be hot during use. Use protection as
required to prevent burning.

WARNING

Do not use this unit on or near combustible surfaces
or structures such as wood decks, dry leaves or
grass, vinyl or wood siding, etc. SEE OWNERS
MANUAL FOR IMPORTANT SAFETY INFORMATION.
DO NOT place any closer than 20 feet from any
combustible surface during use.

WARNING

NEVER LEAVE FIRE UNATTENDED!

Do not allow small children near flame. Hot embers
can fly out in breezy conditions. Adequate fire
extinguishing material should be readily available.

WARNING

CARBON MONOXIDE HAZARD

Burning charcoal inside can kill you. It gives off
carbon monoxide, which has no odor. NEVER burn
charcoal inside homes, vehicles or tents.

42804557 01/07/10

PARTS DIAGRAM

B2

B1

A2

A1

C

D

E

G

H

Page 2

PARTS LIST

Key Description Qty.

A1 Large Screen Section with Handle 1
A2 Large Screen Section 1
B1 Small Screen Section with Handle 1

F

B2 Small Screen Section 1
C Wood Grate 1
D Fire Bowl 1
E Upper Ring 1
F Leg Assembly 4
G Lower Ring 1
H Fire Poker/Tool 1

Hardware Kit 1
Assembly Instructions, English 1
Assembly Instructions, French 1

HARDWARE KIT

M6x12 Flat

Head screw

Qty. 6

Item “J”

Small Adjustable Wrench and Phillips Screwdriver required for assembly.

Estimated time to complete assembly: 15 minutes

“L” Bolt

Qty. 2

Item “K”

(Not supplied)

M6x10

screw
Qty. 8

Item “L”

M6 Nut

Qty. 8

Item “M”

PRODUCT ASSEMBLY

Carefully remove all components from the carton. Check your parts against the parts list on page 2.

First, Connect Large Screen Section (A1 and A2) by using three M6x12 flat head screws (J) and three M6 nuts (M),
Repeat to assemble the Small Screen Sections (B1 and B2). Then connect (A) & (B) by inserting an “L” bolt (K) and M6
nut (M) as shown below. Repeat on opposite side.

J

B1

A1

M

J

M

J

A2

Connect Legs (F) to Upper Ring (E) using 4 M6x10 screws (L). Connect Lower ring (G) to Legs (F) using 4 M6x10
screws (L) as shown below..

M

M

B2

K

L

F

G

L

E

Page 3