Page 1
Copper Porcelain
Copper Porcelain
Firebowl
Firebowl
0420110105501187
For Outdoor
Use Only
WARNING
Do not use this unit on or near combustible surfaces or
structures such as wood decks, dry leaves or grass, vinyl
or wood siding, etc. SEE OWNER’S MANUAL FOR
IMPORTANT SAFETY INFORMATION.
WARNING
NEVER LEAVE FIRE UNATTENDED!
Do not allow small children near flame. Hot embers can
fly out in breezy conditions. Adequate fire extinguishing
material should be readily available.
WARNING
CAUTION
THIS UNIT IS HEAVY!
DO NOT assemble without a helper.
CAUTION
Some parts may contain sharp edges – especially as
noted in manual. Wear protective gloves if necessary.
CARBON MONOXIDE HAZARD
Burning charcoal inside can kill you. It gives off carbon
monoxide, which has no odor. NEVER burn charcoal
inside homes, vehicles or tents.
CAUTION
Read and follow all safety statements, warnings,
assembly instructions and use & care directions before
attempting to assemble.
42804115 (05-17-05)
Page 2
STOP!
Missing a part?
No need to go back to the store!
The store where you made your purchase
does not stock parts for this item. If you
need parts, whether they are missing or
damaged, call the Customer Service toll
free Help Line.
Call us and we will gladly ship
the part you need
FREE OF CHARGE.
PARTS LIST
Call Our Help Line
ITEM DESCRIPTION
55700419 LOWER RING KIT
55700420 UPPER RING KIT
55700400 LEG KIT
55700663 FIREBOWL KIT
55700240 ASH CATCHER KIT
42000005 HARDWARE BAG
42804115 ASSEMBLY INSTRUCTIONS
29100446 MESH FIRE SCREEN ASSEMBLY
To insure your satisfaction
and for follow-up service,
register your product
online at:
www.grillregistration.com
Tools required for assembly: Straight or Phillips screwdriver • Adjustable wrench
Page 3
Making sure legs are on the inside of ring, attach legs to lower (smallest) ring using four
from the outside and four on the inside.
1
1/4-20 keps nuts Do not fully tighten until all four legs are attached.
Lower ring
Leg
1/4-20x1/2” carriage bolts
Making sure legs are on the inside of ring, attach legs to upper (largest) ring using four
from the outside and four on the inside.
2
1/4-20 keps nuts Do not fully tighten until all four legs are attached.
Upper ring
1/4-20x1/2” carriage bolts
Page 4
Attach ash catcher to bottom of firebowl using three and three .#10-24x3/8” screws #10-24 keps nuts Do not fully
tighten until all three brackets are attached.
3
Attach fire screen lift bolt to
firescreen with one hex-keps
4
nut.
1/4-20
Ash catcher
Fire screen lift bolt
Fire screen
Page 5
Place firebowl into upper ring,
then place screen onto firebowl.
5
HARDWARE LIST
Hardware is shown actual size. You may have spare hardware after assembly is complete.
1/4-20x1/2”
Carriage Bolt
Qty: 8
#10-24x3/8”
Screw
Qty: 3
1/4-20
Keps Nut
9Qty:
#10-24
Keps Nut
3Qty:
Page 6
Outdoor Fireplace Use & Care
It is recommended that fire ash be removed from your fireplace between each use. Ash from fires that is not removed can
restrict air flow to the fire and promote rusting. NEVER REMOVE HOT OR WARM ASH. MAKE CERTAIN THAT THE
FIREPLACE IS COOL BEFORE REMOVING ASH.
It is recommended that your fireplace be covered between each use. NEVER COVER A HOT OR WARM FIREPLACE.
MAKE CERTAIN THAT THE FIREPLACE IS COOL BEFORE COVERING.
This fireplace is not intended to be used as a primary heat source. DO NOT OVERFILL.
Copper, Stainless Steel and other Metallic Surfaces
Copper, Stainless Steel and other metallic surfaces often found on outdoor fireplaces can patina, change color and blacken
with exposure to outdoor conditions, heat and smoke. This is a natural occurrence that will result in a finish that is unique to
your fireplace. If desired, these effects can be reduced by cleaning the surfaces regularly after each use using soap, water
and an appropriate metal polish.
Painted Steel and Cast Iron Surfaces
Comparable to the patina effect of copper and bronze, a natural protective rust coating can form on painted steel and cast
iron outdoor fireplaces to create an antiqued finish. Outdoor fireplaces that feature a porcelain finish can develop rust on
the screens over time. If desired, high-temperature paint can be used to restore the original finish.
If you notice any of these surface conditions before the outdoor fireplace is used, contact the Service Center for a free
replacement of the defective component. Manufacturing defects are covered under the 90 Day Limited Warranty.
WARNING
CALIFORNIA PROPOSITION 65
Combustion by-products produced when using this
product contain chemicals known to the State of
California to cause cancer, birth defects, and other
reproductive harm.
Limited Warranty
The manufacturer warrants the product for replacement or repair of parts and/or workmanship for a period of 90 days. Paint is not
warranted and willrequire touchup.
These limited warranties are made exclusively to the original customer presenting proof of purchase. These warranties are limited to
non-commercial residential use only. Any returned goods must be shipped prepaid. These warranties do not cover normal wear and
tear or damages resulting fromabuse or misuse. This warranty excludesincidental or consequential cost due to damagesor losses or
property of anynature.
NOTICE: Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an
implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and
you may alsohave other legalrights which mayvary from stateto state.
For further information, contact the manufacturer, toll free at 1-800-232-3398.
Page 7
Please register your product online at:
WWW.GRILLREGISTRATION.COM
(If you register online, you do not need to send in this registration card.)
Page 8
W.C. Bradley Co. • Columbus, GA 31902 • Assembly Instructions © 2005 • Printed in China
Loading...