Charbroil 04301110 Owner's Manual
04201101
Tools needed for assembly: Phillips screwdriver & Adjustable wrench
THIS UNIT IS HEAVY. DO NOT assemble without helper.
Some parts may contain sharp edges - especially as
noted in manual. Wear protective gloves if necessary.
Read and follow all safety statements, warnings,
assembly instructions and use & care directions before
attempting to assemble and cook.
42804009 (02-27-04)
CARBON MONOXIDE HAZARD
Burning charcoal inside can kill you.
It gives off carbon monoxide, which has no odor.
NEVER burn charcoal inside homes,
vehicles or tents.
04301110
STOP!
Missing a part?
No need to go back to the store!
The store where you made your purchase
does not stock parts for this item. If you
need parts, whether they are missing or
damaged, call the Customer Service toll
free Help Line.
Call us and we will gladly ship
the part you need
FREE OF CHARGE.
ITEM DESCRIPTION
55700473 LID KIT
55700474 LOWER BODY KIT
55700476 HANDLE KIT
55700477 SHELF SLAT KIT
55700478 VENT KIT
55700508 ASH DOOR KIT
55700509 WHEEL KIT
55700482 LEG KIT
55700483 BOTTOM SHELF KIT
29000463 FIRE GRATE HANGER
29000461 FIRE GRATE
29000460 ASH DRAWER
49400006 COOKING GRATE (4)
40003010 TEMPERATURE GAUGE
29000453 LID STOP
45601070 LOCKING CASTER
45601080 NON-LOCKING CASTER
49400018 GRATE LIFTING TOOL
42000068 HARDWARE BAG
PARTS LIST
29100322 LEG END CAP
42804009 ASSEMBLY INSTRUCTIONS
55700510 LOGO PLATE KIT
Call Our Help Line
First, pick a suitable location to work. Open the carton and slit the corners. This will give you a protective work surface upon which
to start the assembly. During assembly, refer to page 10 for hardware identification.
1
Stand bottom assembly on end. using two and
nuts Do not fully tighten screws until Step 5 is complete.
per leg. Turn assembly upside-down to attach remaining two legs
(without caster sockets) on left end.
Right
End
Attach legs with caster sockets to right end 1/4-20x2” screws 1/4-20 flange
Leg
With the aid of a helper, turn the
bottom shelf so that the flange is up,
2
and attach to inside holes near ends of
legs using four and
1/4-20 flange nuts Do not fully
tighten screws until Step 5 is
complete.
1/4-20x2” screws
.
Caster sockets
in ends of legs.
Bottom assembly
Left
End
Bottom shelf
With the grill positioned as shown below. Slide the locking caster (with tab) into insert in left front leg. Slide remaining caster into
insert in left rear leg. (Note: When grill stands upright, these will be the right legs.)
3
Rear leg
Locking caster
with tab
Front leg
Insert into wheel, then slide onto bolt. Insert bolt into hole in end of rear leg and secure with .
axle bolt spacer large hitch pin
Repeat this procedure to attach wheel to front leg.
4
Axle boltWheelSpacerLarge hitch pin
Rear leg
Front leg
Loading...