Charbroil 01309400 Owner's Manual
BBQ and Grill
0420110101309400
Tools needed for
assembly:
Phillips screwdriver
Adjustable wrench
THIS UNIT IS HEAVY. DO NOT assemble without helper.
Some parts may contain sharp edges - especially as noted in
manual. Wear protective gloves if necessary.
Read and follow all safety statements, warning, assembly
instructions and use & care directions before attempting to
assemble and cook.
CARBON MONOXIDE HAZARD
Burning charcoal inside can kill
you. It gives off carbon monoxide,
which has no odor. NEVER burn
charcoal inside homes, vehicles
or tents.
42803987 (11-21-03)
STOP!
Missing a part?
No need to go back to the store!
The store where you made your purchase
does not stock parts for this item. If you
need parts, whether they are missing or
damaged, call the Customer Service toll
free Help Line.
Call us and we will gladly ship
the part you need
FREE OF CHARGE.
ITEM DESCRIPTION
55700473 LID KIT
55700474 LOWER BODY KIT
55700476 HANDLE KIT
55700477 SHELF SLAT KIT
55700478 VENT KIT
55700479 ASH DOOR KIT
55700480 WHEEL KIT
55700481 LOGO PLATE KIT
55700482 LEG KIT
55700483 BOTTOM SHELF KIT
40011231 CARTON
29000463 FIRE GRATE HANGER
29000461 FIRE GRATE
29000460 ASH DRAWER
49400006 COOKING GRATE (4)
40003010 TEMPERATURE GAUGE
29000453 LID STOP
45601070 LOCKING CASTER
45601080 NON-LOCKING CASTER
49400018 GRATE LIFTING TOOL
PARTS LIST
42000057 HARDWARE BAG
29100322 LEG END CAP
42803987 ASSEMBLY INSTRUCTIONS
Call Our Help Line
First, pick a suitable location to work. Open the carton and slit the corners. This will give you a protective work surface upon which
to start the assembly. During assembly, refer to page 10 for hardware identification.
1
Stand bottom assembly on end. Attach legs to one end using two and per leg.
tighten screws until Step 5 is complete.
Leg
Turn assembly upside-down to attach remaining two legs on opposite end.
Bottom assembly
1/4-20x2” screws 1/4-20 flange nuts Do not fully
With the aid of a helper, turn the
bottom shelf so that the flange is up,
2
and attach to inside holes near ends of
legs using four and
1/4-20 flange nuts Do not fully
tighten screws until Step 5 is
complete.
1/4-20x2” screws
.
Bottom shelf
With the grill positioned as shown below, push the leg inserts into end of legs to your left. (Note: When grill stands upright, these
will be the right legs.) Slide the locking caster (with tab) into insert in front leg. Slide remaining caster into insert in rear leg.
3
Rear leg
Locking caster
with tab
Front leg
Leg
Insert
axle bolt spacer large hitch pin
Insert into wheel, then slide onto bolt. Insert bolt into hole in end of rear leg and secure with .
Repeat this procedure to attach wheel to front leg.
4
Axle boltWheelSpacerLarge hitch pin
Rear leg
Front leg
Loading...