Channel Vision TE110, C-0920 User Manual

CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
TE110 / C-0920
Telephone Entry system
product with new or rebuilt parts, free of charge in the USA, for two
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied by
Channel VisionTechnology, or failures due to accident, misuse, abuse,
or alteration of the equipment. This warranty is extended only to the
original purchaser, and a purchase receipt, invoice, or other proof of
original purchase date will be required before warranty repairs are
provided.
(800) 840-0288 toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Strikeduration
SecondsS1 S2 S3
3 off off off Off 3 No * 5off off on
8 off on off 15 off on on 20 on off off 40 on off on
100 on on off 240 on on on
S4 S5 S6
On 5 Yes #
#ofrings
Accessories included:
Power Supply
12VAC 500mA
2x3ring
patern
Keyon
phone
Vision Technology, your dealer or any factory-authorized service
center.
500-026 RevC
ISCHER AVENUE •C
234 F
OSTA MESA, CA 92626
(714) 424-6500 • (800) 840-0288 • (714) 424-6510 fax
www.channelvision.com • email: sales@channelvision.com
© 2003, CHANNEL VISION™
The provides communication between the front door and any
7
TE110
phone in the house. When a visitor presses the doorbell button the phones in the house will respond with a distinctive ring. The home owner can then speak to the visitor by answering any of the ringing phones in the house.
Basic Connection
Telephone Service Provider
12VAC 500mA
House
Telephones
Connect 2 Wires Between
Your Door Plate And The TE110
Two Door Application:
1. Complete the basic installation, setting the TE110 to respond to the # key on your telephone.
2. Connect the house phones output from the first TE110 to the line in on the second TE110.
3. Configure the second TE110 to respond to the * key on your telephone.
4. Set both units for different distinctive ring patterns.
Two Door Operation:
When you hear the distinctive ring pattern selected above:
within 20 seconds -
simply pick up the telephone to be
connected to the door speaker.
after 20 seconds
- pick up the telephone and press ## to be connected to the front door speaker, or ** to be connected to the back door speaker.
On
Off
2
Power
Line
S4
Te l
S5
Strike duration
Seconds S1 S2 S3
3
off off
off
off
off
5
on
off
8
on
off
15
off
on
20
off
on
40
on
on
120
on
on
240
S6
Intercom
On
Off
on off on off on off on
S4S5S6
5
Yes
No
3
#of rings
2x3ring
On
Off
Back Side view
Door Plate Connection
(IU-xxxx or DP-xxxx)
#
*
Keyon
patern
phone
S5
S4
5
3
# of rings
Yes
No
2x3 ring
patern
S6
#
*
Key on
phone
Front Side view
Specifications:
REN:
Power Supply:
Dimensions:
C-0902:
Specifications subject to change without notice.
>5
12VAC 500mA
6.5” x 5.0” x 2.4”
Front Door - Back Door Application
Basic Installation Steps:
12VAC 500mA
12VAC 500mA
Power
Telephone
Service
Provider
Line
Te l
Strike duration
Seconds S1 S2 S3
3 5
8 15 20 40
120 240
off off off off on on on on
off off off
off off
on
off
on on
on
off
on
on
off
on
on
Intercom
S4S5S6
5
On
Off
3
#of rings
Yes
#
No
*
2x3ring
Keyon
patern
phone
Front Door
Set dip switches to activate the
doorplate whenever ## is pressed.
House
Telephones
1. Mount the TE110 near the main telephone distribution center of the house and attach the telephone line from the service provider to the connection labeled “Line”
.
2. Connect the main house phone distribution system to the wire terminals labeled “Tel”.
3. Connect the TE110 to the Chanel Vision DP or IU series door plate. Note:
have the small circuit board shown
if your IU or DP door plate does not
in this manual, you need an upgrade kit (model IU-U or DP-U). Please contact your sales person for details.
4. Connect power supply.
Basic Configuration:
Configure switches S4 and S5 to select the desired ring
pattern.
Set switch S6 to either # or * to determine which key will
activate the system.
Back Door
Basic Operation:
When you hear the distinctive ring pattern selected above:
Power
Line
Te l
Intercom
within 20 seconds -
simply pick up the telephone to be
connected to the door speaker.
after 20 seconds
- pick up the telephone and press ## (or **)
to be connected to the door speaker.
If you are already on the phone when the doorbell button is
pressed you will hear a call waiting tone. Simply press ##
Strike duration
Seconds S1 S2 S3
3
off off
5
off
8
off
15
on
20
on
40
on
120
on
240
6
off off off on on off off on on
S4S5S6
5
On
Yes
#
Off
No
3
on off on off on off on
*
#of rings
2x3ring
Keyon
patern
phone
Set dip switches to activate the
doorplate whenever ** is pressed.
(or **) to put your call on hold while you are connected to the door speaker. Press ## (or **) to return to your call.
3
12VAC 500mA
TE110DS Connection Diagram
The is an optional relay that works with the TE110 to control
TE110DS
an electronic opener.
House
Telephones
Telephone ServiceProvider
Power
Line
Te l
Intercom
TE110DS
(Sold Separately)
Strike
power supply
TE110DS Installation Steps:
1. Complete Basic installation.
2. Connect the TE110DS (sold separately) in-line between the main board and small board.
Basic Configuration:
Configure switches S1, S2 and S3 to select the duration of
the TE110DS relay closure.
Basic Operation:
To close the door strike relay while you are already
communicating with the door speaker, press #7 (or *7).
To close the door strike relay when you are not
communicating with the door speaker, press ## (or **) and then press #7 (or *7).
On Off
4
S1
S2
S3
Strike duration
Seconds S1 S2 S3
3
off
off off off
off
5
on
off
8
on
off
15
off
on
20
off
on
40
on
on
120
on
on
240
S4S5S6
5
On
Yes
#
Off
No
3
on off on off on off on
*
#of rings
2x3ring
Keyon
patern
phone
Strike duration
Seconds S1 S2 S3
3
off off
5
off
8
off
15
on
20
on
40
on
120
on
240
off off
on
off
off
on
on
on
off
off
on
off on
off
on
on
To Strike
Mechanism
Door Plate Connection
(IU-xxxx or DP-xxxx)
TE110DS Connection Details
From TE110
To Companion Board
Strike
power supply
To Strike
Mechanism
5
Loading...